Kurita Masakazu, Matsumoto Daisuke, Shigeura Tomokuni, Sato Katsujiro, Gonda Koichi, Harii Kiyonori, Yoshimura Kotaro
Tokyo and Yokohama, Japan From the Department of Plastic Surgery, University of Tokyo School of Medicine; Department of Plastic Surgery, Kyorin University School of Medicine; and Division of Research and Development, Biomaster, Inc.
Plast Reconstr Surg. 2008 Mar;121(3):1033-1041. doi: 10.1097/01.prs.0000299384.53131.87.
Although injective autologous fat transplantation is one of the most attractive options for soft-tissue augmentation, problems such as unpredictability and fibrosis resulting from fat necrosis limit its universal acceptance. Centrifugation is one of most common methods for overcoming these difficulties. This study was performed to investigate quantitatively the effects of centrifugation on liposuction aspirates to optimize centrifugal conditions for fat transplantation and isolation of adipose-derived stem cells.
Liposuction aspirates, obtained from eight healthy female donors, were either not centrifuged or centrifuged at 400, 700, 1200, 3000, or 4200 g for 3 minutes. The volumes of the oil, adipose, and fluid portions and numbers of blood cells and adipose-derived cells in each portion were examined. The processed adipose tissues (1 ml) were injected into athymic mice, and grafts were harvested and weighed at 4 weeks. Morphologic alterations were observed using light and scanning electron microscopy.
Centrifugation concentrated adipose tissues and adipose-derived stem cells in the adipose portion and partly removed red blood cells from the adipose portion. Centrifugation at more than 3000 g significantly damaged adipose-derived stem cells. Centrifugation enhanced graft take per 1 ml centrifuged adipose but reduced calculated graft take per 1 ml adipose before centrifugation.
Excessive centrifugation can destroy adipocytes and adipose-derived stem cells, but appropriate centrifugation concentrates them, resulting in enhanced graft take. The authors tentatively recommend 1200 g as an optimized centrifugal force for obtaining good short- and long-term results in adipose transplantation.
尽管自体脂肪注射移植是软组织填充最具吸引力的选择之一,但诸如脂肪坏死导致的不可预测性和纤维化等问题限制了其广泛应用。离心是克服这些困难最常用的方法之一。本研究旨在定量研究离心对抽脂吸出物的影响,以优化脂肪移植和脂肪来源干细胞分离的离心条件。
从8名健康女性供体获取的抽脂吸出物,要么不进行离心,要么分别以400、700、1200、3000或4200g离心3分钟。检测各部分油、脂肪和液体部分的体积以及血细胞和脂肪来源细胞的数量。将处理后的脂肪组织(1ml)注射到无胸腺小鼠体内,4周后取出移植组织并称重。使用光学显微镜和扫描电子显微镜观察形态学改变。
离心使脂肪组织和脂肪来源干细胞集中在脂肪部分,并部分去除了脂肪部分的红细胞。3000g以上的离心显著损伤脂肪来源干细胞。离心提高了每1ml离心脂肪的移植成活率,但降低了离心前每1ml脂肪计算的移植成活率。
过度离心会破坏脂肪细胞和脂肪来源干细胞,但适当离心可使其浓缩,从而提高移植成活率。作者初步推荐1200g作为优化的离心力,以在脂肪移植中获得良好的短期和长期效果。