Suppr超能文献

诊室美白联合冠内漂白对牙釉质与牙本质粘结强度及牙本质形态的影响

The effect of in-office in combination with intracoronal bleaching on enamel and dentin bond strength and dentin morphology.

作者信息

Amaral Cristiane, Jorge Ana, Veloso Katia, Erhardt Maria, Arias Vanessa, Rodrigues Jose Augusto

机构信息

Department of Restorative Dentistry, Dental Research and Graduate Studies Division, School of Dentistry, Guarulhos University, Guarulhos, Brazil.

出版信息

J Contemp Dent Pract. 2008 Jul 1;9(5):17-24.

Abstract

AIM

The aim of this study was to evaluate in vitro effects of the combination of in-office and intracoronal bleaching on enamel and dentin bond strength and on dentin morphology.

METHODS AND MATERIALS

Bleaching treatment was performed on 128 bovine teeth for three weeks. Intracoronal bleaching was performed in groups G1 to G3, and in the other groups a combination of in-office and intracoronal bleaching was performed. The following agents and materials were used (n=16): G1- sodium perborate and water (SP); G2- 37% carbamide peroxide (CP); G3- 35% hydrogen peroxide (HP); G4- HP + cotton pellet soaked in water (CPW); G5- HP + SP; G6- HP + CP; G7- HP + HP; and G8- CPW (control). Seven days after bleaching treatment the teeth were sectioned into two halves. One half of each tooth was ground to obtain a flat dentin surface. Dentin and enamel fragments were treated with a dentin/enamel resin adhesive. Resin composite was inserted in two increments and polymerized for 20 seconds. Following the restorative procedures, specimens were sectioned into beams with a rectangular cross-sectional area of approximately 1 mm2. Microtensile testing was performed in a universal testing machine. Bond strengths (in MPa) were calculated and the data were submitted to an analysis of variance (ANOVA) and the Tukey test (a=0.05). For the scanning electron microscopy (SEM) observation, the exposed pulp chambers (n=5) were fixed, dehydrated, dried in a Critical Point dryer, and gold-sputter coated for analysis at standardized magnifications (500X, 1000X, and 2000X).

RESULTS

None of the bleaching techniques reduced the enamel bond strength, the best results observed were with the intracoronal treatments with SP and HP. In dentin all bleaching techniques reduced the bond strength with the exception of the in-office HP application technique. The SEM results demonstrated similar dentin surfaces for the G1, G3, G6, and G7 groups with more open dentin tubules found than in the other groups.

CONCLUSION

None of the bleaching techniques tested reduced the bond strength of enamel, but they all reduced the bond strength of dentin with the exception of the group only treated with in-office bleaching using 35% HP. The worst bond strength results to dentin were observed in groups that received intracoronal bleaching with SP.

摘要

目的

本研究旨在评估诊室漂白与冠内漂白联合应用对牙釉质和牙本质粘结强度以及牙本质形态的体外影响。

方法和材料

对128颗牛牙进行为期三周的漂白处理。在G1至G3组进行冠内漂白,其他组进行诊室漂白与冠内漂白联合应用。使用以下试剂和材料(n = 16):G1 - 过硼酸钠与水(SP);G2 - 37% 过氧化脲(CP);G3 - 35% 过氧化氢(HP);G4 - HP + 浸于水中的棉球(CPW);G5 - HP + SP;G6 - HP + CP;G7 - HP + HP;以及G8 - CPW(对照组)。漂白处理七天后,将牙齿切成两半。每颗牙齿的一半进行研磨以获得平整的牙本质表面。牙本质和牙釉质碎片用牙本质/牙釉质树脂粘结剂处理。分两层填入树脂复合材料并聚合20秒。修复操作完成后,将标本切成横截面面积约为1平方毫米的梁状。在万能试验机上进行微拉伸测试。计算粘结强度(单位为MPa),数据进行方差分析(ANOVA)和Tukey检验(α = 0.05)。对于扫描电子显微镜(SEM)观察,将暴露的髓腔(n = 5)固定、脱水、在临界点干燥器中干燥,然后进行金溅射镀膜,以在标准化放大倍数(500X、1000X和2000X)下进行分析。

结果

没有一种漂白技术降低牙釉质粘结强度,观察到的最佳结果是使用SP和HP进行冠内处理。在牙本质方面,除诊室应用HP的技术外,所有漂白技术均降低了粘结强度。SEM结果显示,G1、G3、G6和G7组的牙本质表面相似,与其他组相比,发现有更多开放的牙本质小管。

结论

所测试的漂白技术均未降低牙釉质的粘结强度,但除仅使用35% HP进行诊室漂白的组外,它们均降低了牙本质的粘结强度。在接受SP冠内漂白的组中,观察到对牙本质的粘结强度结果最差。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验