Rothgeb David W, Hossain Ekram, Kuo Angela T, Troyer Jennifer L, Jarrold Caroline Chick, Mayhall Nicholas J, Raghavachari Krishnan
Department of Chemistry, Indiana University, 800 East Kirkwood Avenue, Bloomington, Indiana 47405, USA.
J Chem Phys. 2009 Mar 28;130(12):124314. doi: 10.1063/1.3096414.
Addition of H(2)O and D(2)O to small tungsten suboxide cluster anions W(x)O(y)(-) (x = 1-4; y < or = 3x) was studied using mass spectrometric measurements from a high-pressure fast flow reactor. Within the WO(y)(-) mass manifold, which also includes WO(4)H(-), product masses correspond to the addition of one to three H(2)O or D(2)O molecules. Within the W(2)O(y)(-) cluster series, product distributions suggest that sequential oxidation W(2)O(y)(-) + H(2)O/D(2)O --> W(2)O(y+1)(-) + H(2)/D(2) occurs for y < 5, while for W(2)O(5)(-), W(2)O(6)H(2)(-)/W(2)O(6)D(2)(-) is primarily produced. W(2)O(6)(-) does not appear reactive. For the W(3)O(y)(-) cluster series, sequential oxidation with H(2) and D(2) production occurs for y < 6, while W(3)O(6)(-) and W(3)O(7)(-) produce W(3)O(7)H(2)(-)/W(3)O(7)D(2)(-) and W(3)O(8)H(2)(-)/W(3)O(8)D(2)(-), respectively. Lower mass resolution in the W(4)O(y)(-) mass range prevents definitive product assignments, but intensity patterns suggest that sequential oxidation with H(2)/D(2) evolution occurs for y < 6, while W(4)O(y+1)H(2)(-)/W(4)O(y+1)D(2)(-) products result from addition to W(4)O(6)(-) and W(4)O(7)(-). Based on bond energy arguments, the H(2)/D(2) loss reaction is energetically favored if the new O-W(x)O(y)(-) bond energy is greater than 5.1 eV. The relative magnitude of the rate constants for sequential oxidation and H(2)O/D(2)O addition for the x = 2 series was determined. There are no discernable differences in rate constants for reactions with H(2)O or D(2)O, suggesting that the H(2) and D(2) loss from the lower-oxide/hydroxide intermediates is very fast relative to the addition of H(2)O or D(2)O.
利用高压快速流动反应器的质谱测量研究了向小氧化钨簇阴离子W(x)O(y)(-)(x = 1 - 4;y ≤ 3x)中添加H₂O和D₂O的情况。在WO(y)(-)质量范围内,其中还包括WO₄H(-),产物质量对应于添加一到三个H₂O或D₂O分子。在W₂O(y)(-)簇系列中,产物分布表明,当y < 5时,会发生连续氧化反应W₂O(y)(-) + H₂O/D₂O → W₂O(y + 1)(-) + H₂/D₂,而对于W₂O₅(-),主要生成W₂O₆H₂(-)/W₂O₆D₂(-)。W₂O₆(-)似乎没有反应活性。对于W₃O(y)(-)簇系列,当y < 6时会发生连续氧化并产生H₂和D₂,而W₃O₆(-)和W₃O₇(-)分别生成W₃O₇H₂(-)/W₃O₇D₂(-)和W₃O₈H₂(-)/W₃O₈D₂(-)。W₄O(y)(-)质量范围内较低的质量分辨率妨碍了对产物的确切归属,但强度模式表明,当y < 6时会发生连续氧化并伴有H₂/D₂逸出,而W₄O(y + 1)H₂(-)/W₄O(y + 1)D₂(-)产物是由添加到W₄O₆(-)和W₄O₇(-)上形成的。基于键能的观点,如果新的O - W(x)O(y)(-)键能大于5.1 eV,H₂/D₂损失反应在能量上更有利。确定了x = 2系列连续氧化和添加H₂O/D₂O的速率常数的相对大小。与H₂O或D₂O反应的速率常数没有明显差异,这表明相对于添加H₂O或D₂O,低价氧化物/氢氧化物中间体的H₂和D₂损失非常快。