University Hospital Zurich, Zurich, Switzerland.
J Assoc Res Otolaryngol. 2010 Sep;11(3):329-41. doi: 10.1007/s10162-010-0207-6. Epub 2010 Feb 18.
It has been reported that the physiological motion of the stapes in human and several animals in response to acoustic stimulation is mainly piston-like at low frequencies. At higher frequencies, the pattern includes rocking motions around the long and short axes of the footplate in human and animal ears. Measurements of such extended stapes motions are highly sensitive to the exact angulation of the stapes in relation to the measurement devices and to measurement errors. In this study, velocity in a specific direction was measured at multiple points on the footplates of human temporal bones using a Scanning Laser Doppler Vibrometer (SLDV) system, and the elementary components of the stapes motions, which were the piston-like motion and the rocking motions about the short and long axes of the footplate, were calculated from the measurements. The angular position of a laser beam with respect to the stapes and coordinates of the measurement points on the footplate plane were calculated by correlation between the SLDV measurement frame and the footplate-fixed frame, which was obtained from micro-CT images. The ratios of the rocking motions relative to the piston-like motion increased with frequency and reached a maximum around 7 kHz.A novel method for quantitatively assessing measurements of complex stapes motions and error boundaries of the motion components is presented. In the frequency range of 0.5 to 8 kHz, the magnitudes of the piston-like and two rocking motions were larger than estimated values of the corresponding upper error bounds.
据报道,在人类和几种动物中,镫骨的生理运动对声音刺激的反应主要是低频时的活塞样运动。在更高的频率下,模式包括围绕足板的长轴和短轴的摆动运动。在人类和动物耳朵中,此类扩展镫骨运动的测量对镫骨相对于测量设备的精确角度以及测量误差非常敏感。在这项研究中,使用激光多普勒测振仪 (SLDV) 系统在人颞骨的足板的多个点测量特定方向的速度,并从测量结果中计算出镫骨运动的基本成分,即活塞样运动和围绕足板长轴和短轴的摆动运动。激光束相对于镫骨的角度位置和足板平面上测量点的坐标通过 SLDV 测量框架与基于微 CT 图像获得的足板固定框架之间的相关性来计算。相对于活塞样运动的摆动运动的比值随频率增加而增加,并在约 7 kHz 左右达到最大值。提出了一种用于定量评估复杂镫骨运动测量和运动分量误差边界的新方法。在 0.5 至 8 kHz 的频率范围内,活塞样运动和两个摆动运动的幅度大于相应上误差边界的估计值。