Department of Civil Engineering, University of Ottawa, 161 Louis Pasteur, Ottawa, Canada.
Waste Manag. 2010 Oct;30(10):1772-9. doi: 10.1016/j.wasman.2010.01.033. Epub 2010 Feb 19.
High temperature and pressure microwave (MW) irradiation was investigated as a pre-treatment to enhance anaerobic biodegradability and methane production from a model kitchen waste (KW). Heating rates of 7.8, 3.9 and 1.9 degrees C/min from room temperature to a final pre-treatment temperature of 175 degrees C with 1 min temperature holding time were tested. MW irradiation was successful in solubilization of particulate chemical oxygen demand (COD) resulting in higher soluble COD, protein and sugar concentrations in the supernatant phase (<0.45 microm) as well as in the whole fraction of pretreated KW compared to controls (not pretreated). Anaerobic biodegradability of the supernatant and whole fractions of pretreated KW was assessed by using a batch biochemical methane potential assay (BMP) at 33 degrees C. Although the highest level of solubilization was achieved at a heating rate of 1.9 degrees C/min, improvement in anaerobic biodegradability was observed only at the fastest heating rate of 7.8 degrees C/min for whole waste and for all conditions with the supernatant phase. BMP indicated increased biodegradability of between 5% and 16% for the supernatant fraction relative to controls. For the whole fraction, anaerobic biodegradability improved by 9% at a heating rate of 7.8 degrees C/min.
高温高压微波(MW)辐照作为一种预处理方法,用于提高模型厨余垃圾(KW)的厌氧生物降解性和甲烷产量。测试了从室温到最终预处理温度 175°C 的加热速率分别为 7.8°C/min、3.9°C/min 和 1.9°C/min,且保持 1 分钟的温度。MW 辐照成功地实现了颗粒状化学需氧量(COD)的溶解,导致上清液相(<0.45μm)和预处理 KW 的整个部分中可溶性 COD、蛋白质和糖浓度更高,与对照(未经预处理)相比。采用 33°C 的批式生物甲烷潜力测定(BMP)评估了上清液和预处理 KW 整个部分的厌氧生物降解性。尽管在 1.9°C/min 的加热速率下达到了最高的溶解水平,但仅在最快的 7.8°C/min 加热速率下,对于整个废物和所有条件下的上清液相,才观察到厌氧生物降解性的提高。BMP 表明,与对照相比,上清液部分的生物降解性提高了 5%至 16%。对于整个部分,在 7.8°C/min 的加热速率下,厌氧生物降解性提高了 9%。