Suppr超能文献

新型髋关节约束矫形器对截瘫步行的步态评估。

Gait evaluation of a novel hip constraint orthosis with implication for walking in paraplegia.

机构信息

Department of Biomedical Engineering,CaseWestern Reserve University, Cleveland, OH 44106, USA.

出版信息

IEEE Trans Neural Syst Rehabil Eng. 2010 Dec;18(6):610-8. doi: 10.1109/TNSRE.2010.2047594. Epub 2010 Apr 8.

Abstract

The aim of this study was to determine the effects of a newly developed reciprocal gait orthosis (RGO) with a variable constraint hip mechanism (VCHM) on the kinematics and kinetics of normal gait. The VCHM was compared with the isocentric reciprocating gait orthosis (IRGO) for walking after paraplegia. Both the VCHM and the IRGO were evaluated with able-bodied volunteers with the hip reciprocating mechanisms coupled and uncoupled. The VCHM was further evaluated with context-dependent coupling based on a finite-state control algorithm utilizing information from brace-mounted sensors. Walking performance for each brace condition was also compared to normal walking without an orthosis. Without the hip controller, the VCHM affected the kinematics of the hip joint in a similar manner as the IRGO, regardless of whether the hip reciprocator was coupled or uncoupled. With the controller active, hip kinematics with the VCHM were closer to normal gait than with the IRGO or any other condition tested (Intraclass correlation coefficient, ICC=0.96). The effects of the braces on the knee and ankle angles were not as prominent as their effects on the hip angles. In terms of kinetics, the VCHM with controller active allowed the generation of joint moments that were closer to normal (ICC=0.80) than the IRGO with hips coupled (ICC= 0.68). There was no statistically significant difference between the various conditions tested in terms of step-length and no statistically significant difference in the preferred walking speed between the IRGO and normal walking, whether or not the hips were coupled. However, there was a 25% reduction in walking speed with the VCHM when compared to normal, and the relative magnitudes of the EMG activity of three muscles (tibialis anterior, quadriceps, and hamstrings) were also higher with the VCHM than with either the IRGO or normal gait, likely due to the additional weight of the mechanism. Overall, the VCHM with controller active provided smooth control of the hip joints via context-dependent coupling and allowed for increased hip flexion relative to the IRGO. The results suggest that the VCHM with controlled joint coupling may eventually be a valuable component of a hybrid system combining functional electrical stimulation (FES) with orthotics.

摘要

本研究旨在确定一种新开发的具有可变约束髋关节机构(VCHM)的交互步态矫形器(RGO)对正常步态的运动学和动力学的影响。比较了 VCHM 与等中心往复步态矫形器(IRGO)在截瘫后行走的效果。在髋关节往复机构耦合和不耦合的情况下,分别对 VCHM 和 IRGO 进行了评估。进一步利用基于有限状态控制算法的、利用支具上传感器信息的上下文相关耦合,对 VCHM 进行了评估。还将每种支具条件下的行走性能与无矫形器的正常行走进行了比较。没有髋关节控制器,VCHM 影响髋关节运动学的方式与 IRGO 相似,无论髋关节往复器是否耦合。当控制器激活时,VCHM 的髋关节运动学比 IRGO 或任何其他测试条件(组内相关系数 ICC=0.96)更接近正常步态。支具对膝关节和踝关节角度的影响不如对髋关节角度的影响明显。就动力学而言,与髋关节耦合的 IRGO(ICC=0.68)相比,具有控制器的 VCHM 可以产生更接近正常的关节力矩(ICC=0.80)。在步长方面,各种测试条件之间没有统计学上的显著差异,在髋关节耦合的情况下,IRGO 与正常行走的首选行走速度之间也没有统计学上的显著差异。然而,与正常行走相比,VCHM 的行走速度降低了 25%,并且与 IRGO 或正常步态相比,VCHM 的三个肌肉(胫骨前肌、股四头肌和腘绳肌)的肌电图活动的相对幅度也更高,这可能是由于机构的额外重量所致。总的来说,具有控制器的 VCHM 通过上下文相关耦合实现了髋关节的平滑控制,并允许相对于 IRGO 增加髋关节的屈曲。结果表明,具有受控关节耦合的 VCHM 可能最终成为将功能性电刺激(FES)与矫形器相结合的混合系统的有价值组成部分。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验