Department of Endodontology, Academic Centre for Dentistry Amsterdam (ACTA) University of Amsterdam and Free University Amsterdam, Louwesweg, the Netherlands.
Int Endod J. 2010 Nov;43(11):995-1000. doi: 10.1111/j.1365-2591.2010.01740.x. Epub 2010 Aug 16.
To compare the incidence of dentinal defects (cracks and craze lines) after root canal preparation, lateral compaction and continuous wave compaction of gutta-percha and AH26 sealer.
Two hundred mandibular premolar teeth were divided into four groups with similar average canal diameters (n=50). One group was left untreated and served as the control. The other three groups were prepared with ProTaper rotary instruments up to size F4. After preparation, one group was left unfilled while two groups were filled with gutta-percha and AH26 using either lateral compaction or the continuous wave technique. Roots were then sectioned at 3, 6 and 9 mm from the apex and inspected under a microscope. The appearance of dentinal defects was noted as well as the minimum and mean remaining dentine thickness. Chi-square tests were performed to compare the incidence of dentinal defects between the groups (α=0.05), and Pearson correlation test was performed to check the correlation between defects and root level or remaining dentine thickness.
The unprepared control group had no dentinal defects. The other groups exhibited significantly more defects than the unprepared group (P<0.05). There was no difference in the incidence of defects between the two filling techniques. There was no correlation between the appearance of defects and level of the root or remaining dentine thickness.
In extracted teeth, dentinal defects were observed in roots filled with gutta-percha and AH26 using the lateral compaction and continuous wave techniques.
比较根管预备、侧向加压和连续波加压牙胶和 AH26 根管封闭剂后牙本质缺陷(裂纹和微裂)的发生率。
200 颗下颌前磨牙分为 4 组,平均根管直径相似(n=50)。一组不做任何处理作为对照。其余三组用 ProTaper 手用镍钛锉预备至 F4 号。预备后,一组不充填,两组分别用侧向加压或连续波技术用牙胶和 AH26 充填。然后从根尖 3、6、9mm 处将牙根切成薄片,在显微镜下观察。记录牙本质缺陷的外观以及最小和平均剩余牙本质厚度。采用卡方检验比较各组牙本质缺陷的发生率(α=0.05),采用皮尔逊相关检验检查缺陷与根段或剩余牙本质厚度的相关性。
未经处理的对照组无牙本质缺陷。其他组的缺陷明显多于未处理组(P<0.05)。两种充填技术的缺陷发生率无差异。缺陷的出现与根段或剩余牙本质厚度之间无相关性。
在离体牙中,用侧向加压和连续波技术用牙胶和 AH26 充填的根管中观察到牙本质缺陷。