On the influence of environment gases, relative humidity and gas purification on dielectric charging/discharging processes in electrostatically driven MEMS/NEMS devices.

In this paper, we investigate the impact of environment gases and relative humidity on dielectric charging phenomenon in electrostatically actuated micro- and nano-electromechanical systems (MEMS and NEMS). The research is based on surface potential measurements using Kelvin probe force microscopy (KPFM). Plasma-enhanced chemical vapor deposition (PECVD) silicon nitride films were investigated in view of applications in electrostatic capacitive RF MEMS switches. Charges were injected through the atomic force microscope (AFM) tip, and the induced surface potential was measured using KPFM. Experiments have been performed in air and in nitrogen environments, both under different relative humidity levels ranging from 0.02% to 40%. The impact of oxygen gas and hydrocarbon contaminants has been studied for the first time by using different gas purifiers in both air and nitrogen lines. Voltage pulses with different bias amplitudes have been applied during the charge injection step under all investigated environmental conditions in order to investigate the effect of bias amplitude. The investigation reveals a deeper understanding of charging and discharging processes and could further lead to improved operating environment conditions in order to minimize the dielectric charging. Finally, the nanoscale KPFM results obtained in this study show a good correlation with the device level measurements for capacitive MEMS switches reported in the literature.