Department of Radiation Oncology, Emory University School of Medicine, Atlanta, GA 30322, USA.
J Appl Clin Med Phys. 2011 Apr 13;12(3):3467. doi: 10.1120/jacmp.v12i3.3467.
Radiosurgical treatment of cranial or extracranial targets demands accurate positioning of the isocenter at the beam and table isocenter, and immobilization of the target during treatment. For spinal radiosurgery, the standard approach involves matching of cone-beam CT (CBCT) in-room images with the planning CT (pCT) to determine translation and yaw corrections. The purpose of this study was to assess the accuracy of these techniques compared to advanced automatching using mutual information metrics, with consideration given to volume of interest (VOI) and optimizing translations and rotations in all axes. The dosimetric consequences of our current standard matching techniques were also evaluated. Ten consecutive spinal radiosurgery patients treated in the last year were subjected to analysis. For purposes of this analysis, the automatch using mutual information and a VOI was considered to create "the true isocenter" for positioning the patients. Review of the imaging from this automatch confirmed perfect superimposition of the two datasets within the VOI. Matching the CBCT to the pCT using the automatch allowed assessment of the rotations which had been previously ignored. Recalculation of the dose volume histogram was undertaken for each patient, assuming displacement of the true isocenter to the treated isocenter. Comparisons between the delivered doses and the intended doses were made. The mean absolute lateral/vertical/longitudinal translations and vector displacement between the manual CBCT-pCT matching isocenter and the true isocenter were 0.13, -0.05, and -0.39 mm, with a minimum and maximum individual pixel vector shift of 3.2 and 8.94 mm. The mean pitch, yaw, and roll correction for automatch was -0.30°, 0.25°, and 0.97° with a maximum of 1.65°, 2.92°, and 1.43°. Four of ten patients had a significant change in the coverage of the tumor due to lack of correction of translational and rotational errors. The largest errors were observed in patients with small and irregular target volumes. Our initial results show that precise positioning for spinal radiosurgery cannot be accomplished with manual pCT-CBCT matching without a clinical strategy to compensate for rotations. In the absence of this, significant underdosing of the tumor may occur.
颅外或颅外目标的放射外科治疗需要在光束和工作台等中心点准确定位,并在治疗过程中固定目标。对于脊柱放射外科手术,标准方法包括将锥形束 CT(CBCT)室内图像与计划 CT(pCT)进行匹配,以确定平移和偏航校正。本研究的目的是评估与使用互信息度量标准的先进自动匹配相比,这些技术的准确性,并考虑感兴趣体积(VOI)以及在所有轴上优化平移和旋转。还评估了我们当前标准匹配技术的剂量学后果。对去年治疗的 10 例连续脊柱放射外科手术患者进行了分析。为了进行这项分析,使用互信息和 VOI 的自动匹配被认为是为患者定位而创建“真实等中心点”。通过自动匹配查看这两个数据集的图像确认了 VOI 内的完美叠加。使用自动匹配将 CBCT 与 pCT 进行匹配,可以评估以前忽略的旋转。为每个患者重新计算了剂量体积直方图,假设真实等中心点移动到治疗等中心点。对每个患者的真实等中心点与治疗等中心点之间的剂量进行了比较。手动 CBCT-pCT 匹配等中心点与真实等中心点之间的横向/垂直/纵向平移和向量位移的平均值分别为 0.13、-0.05 和-0.39mm,最小和最大个体像素向量偏移分别为 3.2 和 8.94mm。自动匹配的俯仰、偏航和滚动校正平均值分别为-0.30°、0.25°和 0.97°,最大值分别为 1.65°、2.92°和 1.43°。十个患者中有四个由于没有纠正平移和旋转误差,肿瘤的覆盖范围发生了显著变化。最大的误差发生在目标体积小且不规则的患者中。我们的初步结果表明,如果没有临床策略来补偿旋转,仅凭手动 pCT-CBCT 匹配,就无法实现脊柱放射外科手术的精确定位。在没有这种策略的情况下,肿瘤可能会出现剂量不足的情况。