Departments of Radiology and Biomedical Engineering, University of Wisconsin, Madison, Wisconsin 53792, USA.
Med Phys. 2011 Jul;38(7):4232-40. doi: 10.1118/1.3601019.
Design and validate an efficient dual-slot coaxial microwave ablation antenna that produces an approximately spherical heating pattern to match the shape of most abdominal and pulmonary tumor targets.
A dual-slot antenna geometry was utilized for this study. Permutations of the antenna geometry using proximal and distal slot widths from 1 to 10 mm separated by 1-20 mm were analyzed using finite-element electromagnetic simulations. From this series, the most optimal antenna geometry was selected using a two-term sigmoidal objective function to minimize antenna reflection coefficient and maximize the diameter-to-length aspect ratio of heat generation. Sensitivities to variations in tissue properties and insertion depth were also evaluated in numerical models. The most optimal dual-slot geometry of the parametric analysis was then fabricated from semirigid coaxial cable. Antenna reflection coefficients at various insertion depths were recorded in ex vivo bovine livers and compared to numerical results. Ablation zones were then created by applying 50 W for 2-10 min in simulations and ex vivo livers. Mean zone diameter, length, aspect ratio, and reflection coefficients before and after heating were then compared to a conventional monopole antenna using ANOVA with post-hoc t-tests. Statistical significance was indicated for P <0.05.
Antenna performance was highly sensitive to dual-slot geometry. The best-performing designs utilized a proximal slot width of 1 mm, distal slot width of 4 mm +/- 1 mm and separation of 8 mm +/- 1 mm. These designs were characterized by an active choking mechanism that focused heating to the distal tip of the antenna. A dual-band resonance was observed in the most optimal design, with a minimum reflection coefficient of -20.9 dB at 2.45 and 1.25 GHz. Total operating bandwidth was greater than 1 GHz, but the desired heating pattern was achieved only near 2.45 GHz. As a result, antenna performance was robust to changes in insertion depth and variations in relative permittivity of the surrounding tissue medium. In both simulations and ex vivo liver, the dual-slot antenna created ablations greater in diameter than a coaxial monopole (35 mm +/- 2 mm versus 31 mm +/- 2 mm; P<0.05), while also shorter in length (49 mm +/- 2 mm versus 60 mm +/- 6 mm; P < 0.001) after 10 min. Similar results were obtained after 2 and 5 min as well.
Dual-slot antennas can produce more spherical ablation zones while retaining low reflection coefficients. These benefits are obtained without adding to the antenna diameter. Further evaluation for clinical microwave ablation appears warranted.
设计并验证一种高效的双槽同轴微波消融天线,该天线产生近似球形的加热模式,以匹配大多数腹部和肺部肿瘤目标的形状。
本研究采用双槽天线几何形状。使用近端和远端狭缝宽度为 1 至 10 毫米,间隔为 1 至 20 毫米的天线几何形状进行排列,并通过有限元电磁模拟进行分析。从这一系列中,使用两项 sigmoidal 目标函数选择最佳的天线几何形状,以最小化天线反射系数并最大化发热的直径-长度比。还在数值模型中评估了对组织特性和插入深度变化的敏感性。然后,从半刚性同轴电缆中制造出参数分析的最佳双槽几何形状。在离体牛肝中记录了不同插入深度的天线反射系数,并将其与数值结果进行比较。然后在模拟和离体肝脏中施加 50 W 进行 2-10 分钟以创建消融区。然后使用方差分析和事后 t 检验将加热前后的平均区域直径、长度、纵横比和反射系数与传统的单极天线进行比较。P <0.05 表示具有统计学意义。
天线性能对双槽几何形状高度敏感。表现最佳的设计采用近端狭缝宽度为 1 毫米,远端狭缝宽度为 4 毫米 +/- 1 毫米,间隔为 8 毫米 +/- 1 毫米。这些设计的特点是存在主动阻塞机制,将加热集中在天线的远端尖端。在最佳设计中观察到双频带共振,在 2.45 和 1.25 GHz 时的最小反射系数为-20.9 dB。总工作带宽大于 1 GHz,但仅在 2.45 GHz 附近实现所需的加热模式。因此,天线性能对插入深度的变化和周围组织介质的相对介电常数的变化具有很强的鲁棒性。在模拟和离体肝中,双槽天线产生的消融直径大于同轴单极天线(35 毫米 +/- 2 毫米与 31 毫米 +/- 2 毫米;P<0.05),同时长度也更短(49 毫米 +/- 2 毫米与 60 毫米 +/- 6 毫米;P < 0.001)在 10 分钟后。在 2 分钟和 5 分钟后也得到了类似的结果。
双槽天线可以产生更球形的消融区域,同时保持低反射系数。这些好处是在不增加天线直径的情况下获得的。进一步的临床微波消融评估似乎是合理的。