Department of Chemical Engineering, University of Alcalá, 28871 Alcalá de Henares, Madrid, Spain.
Water Res. 2012 Sep 15;46(14):4435-47. doi: 10.1016/j.watres.2012.05.051. Epub 2012 Jun 7.
Synthetic musks have been reported in wastewaters at concentrations as high as tens of micrograms per litre. The two most significant polycyclic musk fragrance compounds are 1,3,4,6,7,8-hexahydro-4,6,6,7,8,8-hexamethylcyclopenta(g)-2-benzopyran (HHCB, trade name galaxolide®) and 7-acetyl-1,1,3,4,4,6-hexamethyltetrahydronaphthalene (AHTN, trade name tonalide®). We report the result of several irradiation and advanced oxidation processes carried out on samples of the effluent of a wastewater treatment plant located in Alcalá de Henares, Madrid. Wastewater samples were pre-ozonated and spiked with 500 ng/L of tonalide or galaxolide in order to obtain final concentrations in the same order as the raw effluent. The treatments assayed were ozonation with and without the addition of hydrogen peroxide (O₃, O₃/H₂O₂), ultraviolet (254 nm low pressure mercury lamp) and xenon-arc visible light irradiation alone and in combination with ozone (UV, O₃/UV, Xe, O₃/Xe) and visible light photocatalytic oxidation using a Ce-doped titanium dioxide photocatalyst performed under continuous oxygen or ozone gas bubbling (O₂/Xe/Ce-TiO₂, O₃/Xe/Ce-TiO₂). In all cases, samples taken at different contact times up to 15 min were analyzed. An analytical method based on stir bar sorptive extraction (SBSE), followed by comprehensive two-dimensional gas chromatography (SBSE-GC × GC-TOF-MS), was used for the automatic searching and evaluation of the synthetic musks and other nonpolar or semipolar contaminants in the wastewater samples. In all cases tonalide was more easily removed than galaxolide. The best results for the latter (more than 75% removal after 5 min on stream) were obtained from ozonation (O₃) and visible light photocatalytic ozonation (O₃/Xe/Ce-TiO₂). A significant removal of both pollutants (∼60% after 15 min) was also obtained during visible light photocatalysis (O₂/Xe/Ce-TiO₂). UV radiation was able to deplete tonalide (+90%) after 15 min but only reduced the concentration of galaxolide to about half of its initial concentration. The toxicity of treated samples decreased for O₃/UV and O₃/Ce-TiO₂, but increased during irradiation processes UV, Xe and Xe/Ce-TiO₂. Ozone treatments tend to decrease toxicity up to a certain dosage, from which point the presence of toxic transformation products has adverse effects on aquatic microorganisms.
合成麝香已在废水中被报道,浓度高达数十微克/升。两种最重要的多环麝香香料化合物是 1,3,4,6,7,8-六氢-4,6,6,7,8,8-六甲基环戊并[g]-2-苯并吡喃(HHCB,商品名 galaxolide®)和 7-乙酰基-1,1,3,4,4,6-六甲基四氢萘(AHTN,商品名 tonalide®)。我们报告了在马德里阿尔卡拉德埃纳雷斯的一家污水处理厂的废水处理厂的废水处理厂的几种辐照和高级氧化工艺的结果。为了获得与原废水相同的顺序的最终浓度,对废水样品进行了预臭氧化并加入 500ng/L 的 tonalide 或 galaxolide。所测试的处理方法是臭氧氧化,单独或与紫外线(254nm 低压汞灯)和氙气-可见光辐照组合,以及使用掺铈二氧化钛光催化剂的可见光光催化氧化,在连续氧气或臭氧气体鼓泡下进行(O₂/Xe/Ce-TiO₂、O₃/Xe/Ce-TiO₂)。在所有情况下,在长达 15 分钟的不同接触时间内取样进行分析。采用基于搅拌棒吸附萃取(SBSE)的分析方法,随后进行二维气相色谱(SBSE-GC×GC-TOF-MS),用于自动搜索和评估废水中的合成麝香和其他非极性或半极性污染物。在所有情况下,tonalide 都比 galaxolide 更容易去除。后者(在 5 分钟后超过 75%的去除率)的最佳结果来自臭氧氧化(O₃)和可见光光催化臭氧氧化(O₃/Xe/Ce-TiO₂)。在可见光光催化(O₂/Xe/Ce-TiO₂)过程中,两种污染物的去除率也显著提高(15 分钟后约 60%)。UV 辐射在 15 分钟后可以耗尽 tonalide(+90%),但只能将 galaxolide 的浓度降低到初始浓度的一半左右。O₃/UV 和 O₃/Ce-TiO₂ 的处理样品的毒性降低,但在 UV、Xe 和 Xe/Ce-TiO₂ 的辐照过程中增加。臭氧处理倾向于在一定剂量下降低毒性,从那时起,有毒转化产物的存在对水生微生物产生不利影响。