Department of Trauma and Orthopedic Surgery, University of Witten/Herdecke, Cologne Merheim Medical Center, Ostmerheimer Straße 200, Cologne 51109, Germany.
BMC Musculoskelet Disord. 2012 Aug 27;13:161. doi: 10.1186/1471-2474-13-161.
This article describes an arthroscopic anterior cruciate ligament (ACL) reconstruction technique with a quadriceps tendon autograft using an anteromedial portal technique.
A 5 cm quadriceps tendon graft is harvested with an adjacent 2 cm bone block. The femoral tunnel is created through a low anteromedial portal in its anatomical position. The tibial tunnel is created with a hollow burr, thus acquiring a free cylindrical bone block. The graft is then passed through the tibial tunnel and the bone block, customized at its tip, is tapped into the femoral tunnel through the anteromedial portal to provide press-fit fixation. The graft is tensioned distally and sutures are tied over a bone bridge at the distal end of the tibial tunnel. From the cylindrical bone block harvested from the tibia the proximal end is customized and gently tapped next to the graft tissue into the tibial tunnel to assure press fitting of the graft in the tibial tunnel. The distal part of the tibial tunnel is filled up with the remaining bone.All patients were observed in a prospective fashion with subjective and objective evaluation after 6 weeks, 6 and 12 months.
Thirty patients have been evaluated at a 12 months follow-up. The technique achieved in 96.7% normal or nearly normal results for the objective IKDC. The mean subjective IKDC score was 86.1 ± 15.8. In 96.7% the Tegner score was the same as before injury or decreased one category. A negative or 1+ Lachman test was achieved in all cases. Pivot-shift test was negative or (+) glide in 86.7%. The mean side-to-side difference elevated by instrumental laxity measurement was 1.6 ± 1.1 mm. Full ROM has been achieved in 92.3%. The mean single one-leg-hop index was 91.9 ± 8.0 at the follow-up.
Potential advantages include minimum bone loss specifically on the femoral side and graft fixation without implants.
本文描述了一种使用前内侧入路技术,以四头肌腱自体移植物进行关节镜前交叉韧带(ACL)重建的技术。
取 5cm 长的四头肌腱移植物,带有 2cm 长的相邻骨块。股骨隧道通过其解剖位置的低前内侧入路创建。胫骨隧道使用空心钻创建,从而获得游离的圆柱形骨块。然后将移植物穿过胫骨隧道,并用特制的尖端将带有骨块的移植物敲入前内侧入路的股骨隧道中,以提供压配固定。移植物在远端拉紧,缝线在胫骨隧道远端的骨桥上系紧。从胫骨上取出的圆柱形骨块的近端进行定制,然后轻轻敲入胫骨隧道旁边的移植物组织中,以确保移植物在胫骨隧道中压配合。胫骨隧道的远端部分用剩余的骨块填充。所有患者均进行前瞻性观察,在 6 周、6 个月和 12 个月时进行主观和客观评估。
30 例患者在 12 个月的随访中进行了评估。该技术在客观 IKDC 中达到 96.7%的正常或接近正常结果。平均主观 IKDC 评分为 86.1±15.8。96.7%的患者的 Tegner 评分与受伤前相同或降低一级。所有病例均获得阴性或 1+Lachman 试验结果。在 86.7%的病例中,髌股关节移位试验结果为阴性或(+)滑动。通过仪器松弛度测量得出的膝关节侧方间隙差值平均升高 1.6±1.1mm。92.3%的患者获得了全关节活动度。在随访时,平均单腿跳跃指数为 91.9±8.0。
潜在的优势包括股骨侧最小的骨质丢失和无植入物的移植物固定。