Suppr超能文献

基于直流磁控溅射制备的氧化钛薄膜晶体管。

Thin film transistor based on TiOx prepared by DC magnetron sputtering.

作者信息

Chung Sung Mook, Shin Jae-Heon, Hong Chan-Hwa, Cheong Woo-Seok

机构信息

Convergence Components and Materials Research Laboratory, Electronics and Telecommunications Research Institute, 161 Gajeong-dong, Yuseong-gu, Daejeon 305-700, Korea.

出版信息

J Nanosci Nanotechnol. 2012 Jul;12(7):5440-3. doi: 10.1166/jnn.2012.6228.

Abstract

This paper reports on the thin film transistor (TFT) based on TiOx prepared by direct current (DC) magnetron sputtering for the application of n-type channel transparent TFTs. A ceramic TiOx target was prepared for the sputtering of the TiO2 films. The structural, optical, and electrical properties of the TiO2 films were investigated after their heat treatment. It is observed from XRD measurement that the TiO2 films show anatase structure having (101), (004), and (105) planes after heat treatment. The anatase-structure TiO2 films show a band-gap energy of approximately 3.20 eV and a transmittance of approximately 91% (@550 nm). The bottom-gate TFTs fabricated with the TiO2 film as an n-type channel layer. These devices exhibit the on-off ratio, the field-effect mobility, and the threshold voltage of about 10(4), 0.002 cm2/Vs, and 6 V, respectively. These results indicate the possibility of applying TiO2 films depositied by DC magnetron sputtering to TiO2-based opto-electronic devices.

摘要

本文报道了基于直流磁控溅射制备的氧化钛(TiOx)薄膜晶体管(TFT),用于n型沟道透明TFT的应用。制备了陶瓷TiOx靶用于溅射TiO2薄膜。对TiO2薄膜进行热处理后,研究了其结构、光学和电学性能。通过X射线衍射(XRD)测量观察到,热处理后的TiO2薄膜呈现出具有(101)、(004)和(105)晶面的锐钛矿结构。锐钛矿结构的TiO2薄膜的带隙能量约为3.20 eV,在550 nm处的透过率约为91%。以TiO2薄膜作为n型沟道层制备了底栅TFT。这些器件的开/关比、场效应迁移率和阈值电压分别约为10(4)、0.002 cm2/Vs和6 V。这些结果表明,通过直流磁控溅射沉积的TiO2薄膜应用于基于TiO2的光电器件具有可能性。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验