Beyar R, Shapiro E P, Graves W L, Rogers W J, Guier W H, Carey G A, Soulen R L, Zerhouni E A, Weisfeldt M L, Weiss J L
Department of Medicine, Johns Hopkins Medical Institutions, Baltimore, Maryland 21205.
Circulation. 1990 Jan;81(1):297-307. doi: 10.1161/01.cir.81.1.297.
We have developed a method to quantify and map regional wall thickening throughout the left ventricle (LV) with magnetic resonance imaging. In contrast to methods that measure planar wall thickness and thickening, this method uses the three-dimensional (3D) geometry of the left ventricle to calculate the perpendicular thickness of the wall. We tested this method at three levels of increasing complexity using 1) phantom studies, 2) in vivo experiments in dogs with normal cardiac function, and 3) in vivo studies in dogs during acute ischemia. Experiments were conducted in 15 open-chest dogs imaged by a 0.38 T iron core magnet. Five short-axis images at end diastole and end systole were obtained with the spin echo technique by use of the QRS as a trigger for end diastole and the second heart sound, S2, to time end systole. After acquisition of preischemic images, acute ischemia was induced by either coronary artery ligation (n = 5) or intracoronary dental rubber injection (n = 5), which produced severe transmural ischemia. By use of computer-aided contouring of the endocardial and epicardial borders, each image was divided into 16 segments with radial lines originating from the midwall centroid. A 3D volume element was defined as that generated by connecting two matched planar segments in two adjacent image planes. This defined 64 volume elements comprising the entire left ventricle. Thickness and thickening before and during ischemia were then calculated by using the planar segments and the 3D volume elements. In phantom studies, the 3D method was accurate, independent of the angle of inclination of the image plane to the phantom wall, whereas the planar method showed considerable overestimation of thickness when the image plane was oblique to the phantom wall. In the dogs before induction of ischemia, the 3D method demonstrated the well-established normal taper in end-diastolic wall thickness from 1.10 +/- 0.02 cm at the base to 1.05 +/- 0.11 cm at the apex (p less than 0.01). By contrast, the planar method did not detect the decrease in thickness toward the apex (1.13 +/- 0.07 cm at the base vs. 1.16 +/- 0.14 cm at the apex, p = NS). During acute ischemia, thickening was calculated by both methods at the center of the ischemic zone defined by Monastral blue nonstaining and compared with the preischemic values.(ABSTRACT TRUNCATED AT 400 WORDS)
我们已经开发出一种利用磁共振成像来量化和绘制整个左心室(LV)区域壁增厚情况的方法。与测量平面壁厚度和增厚的方法不同,该方法利用左心室的三维(3D)几何结构来计算壁的垂直厚度。我们使用1)模型研究、2)心功能正常的犬类体内实验以及3)犬类急性缺血期间的体内研究,在三种复杂度不断增加的水平上测试了该方法。实验在15只开胸犬身上进行,这些犬由一台0.38 T铁芯磁体成像。使用自旋回波技术,以QRS波作为舒张末期的触发信号,以第二心音S2来确定收缩末期,获取舒张末期和收缩末期的五幅短轴图像。在获取缺血前图像后,通过冠状动脉结扎(n = 5)或冠状动脉内注射牙科橡胶(n = 5)诱导急性缺血,这会导致严重的透壁性缺血。通过使用计算机辅助的心内膜和心外膜边界轮廓绘制,每幅图像被用从中壁质心发出的径向线划分为16个节段。一个3D体积单元被定义为由连接两个相邻图像平面中两个匹配的平面节段所生成的单元。这定义了包含整个左心室的64个体积单元。然后使用平面节段和3D体积单元计算缺血前后的厚度和增厚情况。在模型研究中,3D方法是准确的,与图像平面相对于模型壁的倾斜角度无关,而当图像平面相对于模型壁倾斜时,平面方法显示出对厚度的显著高估。在犬类缺血诱导前,3D方法显示出舒张末期壁厚度从基部的1.10±0.02 cm到心尖的1.05±0.11 cm呈现出已确立的正常逐渐变细趋势(p<0.01)。相比之下,平面方法未检测到朝向心尖的厚度减小(基部为1.13±0.07 cm,心尖为1.16±0.14 cm,p =无显著差异)。在急性缺血期间,两种方法都在由莫那斯特蓝不着色定义 的缺血区中心计算增厚情况,并与缺血前的值进行比较。(摘要截断于400字)