Institute of Biochemical and Biomedical Engineering, Chang Gung University, Taoyuan, Taiwan, Republic of China.
PLoS One. 2013;8(1):e54058. doi: 10.1371/journal.pone.0054058. Epub 2013 Jan 30.
Cell sheet-mediated tissue regeneration is a promising approach for corneal reconstruction. However, the fragility of bioengineered corneal endothelial cell (CEC) monolayers allows us to take advantage of cross-linked porous gelatin hydrogels as cell sheet carriers for intraocular delivery. The aim of this study was to further investigate the effects of biopolymer concentrations (5-15 wt%) on the characteristic and safety of hydrogel discs fabricated by a simple stirring process combined with freeze-drying method. Results of scanning electron microscopy, porosity measurements, and ninhydrin assays showed that, with increasing solid content, the pore size, porosity, and cross-linking index of carbodiimide treated samples significantly decreased from 508±30 to 292±42 µm, 59.8±1.1 to 33.2±1.9%, and 56.2±1.6 to 34.3±1.8%, respectively. The variation in biopolymer concentrations and degrees of cross-linking greatly affects the Young's modulus and swelling ratio of the gelatin carriers. Differential scanning calorimetry measurements and glucose permeation studies indicated that for the samples with a highest solid content, the highest pore wall thickness and the lowest fraction of mobile water may inhibit solute transport. When the biopolymer concentration is in the range of 5-10 wt%, the hydrogels have high freezable water content (0.89-0.93) and concentration of permeated glucose (591.3-615.5 µg/ml). These features are beneficial to the in vitro cultivation of CECs without limiting proliferation and changing expression of ion channel and pump genes such as ATP1A1, VDAC2, and AQP1. In vivo studies by analyzing the rabbit CEC morphology and count also demonstrate that the implanted gelatin discs with the highest solid content may cause unfavorable tissue-material interactions. It is concluded that the characteristics of cross-linked porous gelatin hydrogel carriers and their triggered biological responses are in relation to biopolymer concentration effects.
细胞片层介导的组织再生是角膜重建的一种很有前途的方法。然而,生物工程角膜内皮细胞 (CEC) 单层的脆弱性使得我们可以利用交联多孔明胶水凝胶作为细胞片层载体进行眼内递送。本研究的目的是进一步研究生物聚合物浓度(5-15wt%)对通过简单搅拌过程与冷冻干燥法相结合制备的水凝胶片的特性和安全性的影响。扫描电子显微镜、孔隙率测量和茚三酮分析的结果表明,随着固含量的增加,碳化二亚胺处理样品的孔径、孔隙率和交联指数从 508±30µm 显著减小到 292±42µm、59.8±1.1%减小到 33.2±1.9%和 56.2±1.6%减小到 34.3±1.8%。生物聚合物浓度和交联程度的变化极大地影响明胶载体的杨氏模量和溶胀率。差示扫描量热法测量和葡萄糖渗透研究表明,对于具有最高固含量的样品,最高的孔壁厚度和最低的可动水分数可能会抑制溶质传输。当生物聚合物浓度在 5-10wt%范围内时,水凝胶具有高的可冻结水含量(0.89-0.93)和渗透葡萄糖浓度(591.3-615.5µg/ml)。这些特征有利于 CEC 的体外培养,而不会限制增殖并改变离子通道和泵基因如 ATP1A1、VDAC2 和 AQP1 的表达。通过分析兔 CEC 形态和计数的体内研究也表明,具有最高固含量的植入明胶片可能会引起不利的组织-材料相互作用。结论是交联多孔明胶水凝胶载体的特性及其引发的生物学反应与生物聚合物浓度效应有关。