Key Laboratory of Plant Germplasm Enhancement and Specialty Agriculture, Wuhan Botanical Garden, Chinese Academy of Sciences, Wuhan 430074, PR China.
J Microbiol Biotechnol. 2013 Apr;23(4):539-44. doi: 10.4014/jmb.1209.09047.
The effects of culture depth (2-10 cm) and cell density on the growth rate and biomass productivity of Chlorella sp. XQ-200419 were investigated through the use of a selfdesigned open circular pond photobioreactor-imitation system. With increases in culture depths from 2 to 10 cm, the growth rate decreased significantly from 1.08 /d to 0.39 /d. However, the biomass productivity only increased slightly from 8.41 to 11.22 g/m2/d. The biomass productivity (11.08 g/m2/d) achieved in 4 cm culture with an initial OD540 of 0.95 was similar to that achieved in 10 cm culture with an initial OD540 of 0.5. In addition, the duration of maximal areal productivity at a 4 cm depth was prolonged from 1 to 4 days, a finding that was also similar to that of the culture at a 10 cm depth. In both cases, the initial areal biomass densities were identical. Based on these results and previous studies, it can be concluded that the influence of culture depth and cell density on areal biomass productivity is actually due to different areal biomass densities. Under suitable conditions, there are a range of optimal biomass densities, and areal biomass productivity reaches its maximum when the biomass density is within these optimal ranges. Otherwise, biomass productivity will decrease. Therefore, a key factor for high biomass productivity is to maintain an optimal biomass density.
采用自行设计的开放式圆形光生物反应器模拟系统,研究了深度(2-10 cm)和细胞密度对小球藻 XQ-200419 生长速率和生物量生产力的影响。随着培养深度从 2 cm 增加到 10 cm,生长速率从 1.08/d 显著降低至 0.39/d。然而,生物量生产力仅从 8.41 g/m2/d 略微增加到 11.22 g/m2/d。在初始 OD540 为 0.95 的 4 cm 培养中实现的生物量生产力(11.08 g/m2/d)与初始 OD540 为 0.5 的 10 cm 培养中实现的生物量生产力相当。此外,在 4 cm 深度下最大面积生产力的持续时间从 1 天延长到 4 天,这一发现与 10 cm 深度的培养情况相似。在这两种情况下,初始面积生物量密度相同。基于这些结果和以前的研究,可以得出结论,培养深度和细胞密度对面积生物量生产力的影响实际上是由于不同的面积生物量密度。在合适的条件下,存在一系列最佳生物量密度,当生物量密度在这些最佳范围内时,面积生物量生产力达到最大值。否则,生物量生产力将会降低。因此,高生物量生产力的关键因素是保持最佳生物量密度。