Université de Montréal, Montréal, QC, Canada.
Clin Orthop Relat Res. 2013 Aug;471(8):2556-62. doi: 10.1007/s11999-013-3027-2. Epub 2013 May 8.
Radial head alignment is the key to determine elbow reduction after treatment of subluxations or Monteggia fractures. The radiocapitellar ratio (RCR) quantifies the degree of subluxation, by evaluating radial head alignment with the capitellum of the humerus; this ratio is reproducible when measured on true lateral radiographs of nonsubluxated elbows. However, the impact of beam angulation on RCR measurement is unknown.
QUESTIONS/PURPOSES: Our hypotheses were that the RCR of the nonsubluxated elbow would remain in the normal range as the beam angle changed and that the RCR variability would increase for the subluxated elbow with small deviations in the beam angle.
Radiographs were taken of six healthy cadaveric extremities using beam angles ranging from -20° to 20° along the inferosuperior axis and from -20° to 20° along the dorsoventral axis. The same views then were taken of the six arms with anterior radiocapitellum subluxation followed by posterior radiocapitellum subluxation. RCRs were measured by one observer. As a reference value, the RCR was measured in the 0° to 0° position and the difference between each RCR in a nonreference position was subtracted from each RCR reference to obtain the delta-RCR. An ANOVA was performed to assess the main and interactive effects on the RCR measured in each C-arm position compared with the RCR measured on a true lateral radiograph.
The RCR remained in the normal range even as the beam angle of the C-arm varied between -20° and 20°. The position of the beam did not affect the RCR in anteriorly subluxated elbows (p = 0.777), whereas RCR variation increased especially in the presence of posterior radial head subluxation when the C-arm position was 10° or more out of plane (p = 0.006). The inferosuperior malposition of the C-arm had a greater impact on quantification of radial head alignment measurement. Despite that, the RCR measurement is reliable in reduced and subluxated elbows on lateral radiographs with a C-arm position deviation of as much as 20°.
Identification of a subluxated elbow could be made on any lateral radiograph with a beam angulation deviation of as much as 20°. This suggests that the RCR is a useful diagnostic tool for clinical and research purposes, although for subluxated elbows, it is important to pay careful attention to the inferosuperior position of the C-arm.
桡骨头对线是治疗半脱位或孟氏骨折后确定肘部复位的关键。桡肱比值(RCR)通过评估桡骨头与肱骨小头的对位情况来量化半脱位程度;在非半脱位肘部的真实侧位 X 光片上测量时,该比值具有可重复性。然而,光束角度对 RCR 测量的影响尚不清楚。
问题/目的:我们的假设是,在光束角度变化时,非半脱位肘部的 RCR 将保持在正常范围内,并且对于桡骨头小程度半脱位的肘部,RCR 可变性会随着光束角度的小偏差而增加。
使用沿下上轴从-20°到 20°和沿背侧轴从-20°到 20°的光束角度对 6 个健康的尸体上肢进行 X 光拍摄。然后,在前桡骨头半脱位和后桡骨头半脱位后,对 6 个上肢进行相同的拍摄。由一名观察者测量 RCR。作为参考值,在 0°到 0°位置测量 RCR,并从每个非参考位置的 RCR 中减去每个 RCR 参考值,以获得 delta-RCR。进行方差分析,以评估与真实侧位 X 光片相比,在每个 C 臂位置测量的 RCR 的主要和交互作用。
即使 C 臂的光束角度在-20°到 20°之间变化,RCR 仍保持在正常范围内。光束的位置并不影响在前侧半脱位的肘部的 RCR(p=0.777),而当 C 臂位置偏离平面 10°或更多时,RCR 变化尤其增加(p=0.006)。C 臂的下上错位对桡骨头对齐测量的定量有更大的影响。尽管如此,在 C 臂位置偏差高达 20°的侧位 X 光片上,RCR 测量仍然可靠。
在光束角度偏差高达 20°的任何侧位 X 光片上都可以识别出半脱位的肘部。这表明 RCR 是一种用于临床和研究目的的有用诊断工具,尽管对于半脱位的肘部,重要的是要仔细注意 C 臂的下上位置。