IFP Energies nouvelles, 1 et 4 avenue de Bois-Préau, 92852 Rueil-Malmaison, France.
Biotechnol Biofuels. 2013 May 17;6(1):79. doi: 10.1186/1754-6834-6-79.
On-site cellulase production using locally available lignocellulosic biomass (LCB) is essential for cost-effective production of 2nd-generation biofuels. Cellulolytic enzymes (cellulases and hemicellulases) must be produced in fed-batch mode in order to obtain high productivity and yield. To date, the impact of the sugar composition of LCB hydrolysates on cellulolytic enzyme secretion has not been thoroughly investigated in industrial conditions.
The effect of sugar mixtures (glucose, xylose, inducer) on the secretion of cellulolytic enzymes by a glucose-derepressed and cellulase-hyperproducing mutant strain of Trichoderma reesei (strain CL847) was studied using a small-scale protocol representative of the industrial conditions. Since production of cellulolytic enzymes is inducible by either lactose or cellobiose, two parallel mixture designs were performed separately. No significant difference between inducers was observed on cellulase secretion performance, probably because a common induction mechanism occurred under carbon flux limitation. The characteristics of the enzymatic cocktails did not correlate with productivity, but instead were rather dependent on the substrate composition. Increasing xylose content in the feed had the strongest impact. It decreased by 2-fold cellulase, endoglucanase, and cellobiohydrolase activities and by 4-fold β-glucosidase activity. In contrast, xylanase activity was increased 6-fold. Accordingly, simultaneous high β-glucosidase and xylanase activities in the enzymatic cocktails seemed to be incompatible. The variations in enzymatic activity were modelled and validated with four fed-batch cultures performed in bioreactors. The overall enzyme production was maintained at its highest level when substituting up to 75% of the inducer with non-inducing sugars.
The sugar substrate composition strongly influenced the composition of the cellulolytic cocktail secreted by T. reesei in fed-batch mode. Modelling can be used to predict cellulolytic activity based on the sugar composition of the culture-feeding solution, or to fine tune the substrate composition in order to produce a desired enzymatic cocktail.
就地利用当地木质纤维素生物质(LCB)生产细胞酶对于经济高效地生产第二代生物燃料至关重要。为了获得高生产力和产率,纤维素酶(纤维素酶和半纤维素酶)必须以分批补料的方式生产。迄今为止,在工业条件下,LCB 水解物的糖组成对纤维素酶分泌的影响尚未得到彻底研究。
使用小规模方案代表工业条件,研究了糖混合物(葡萄糖、木糖、诱导剂)对葡萄糖去阻遏和纤维素高产突变株里氏木霉(菌株 CL847)分泌纤维素酶的影响。由于纤维素酶的生产可由乳糖或纤维二糖诱导,因此分别进行了两个平行的混合物设计。在纤维素酶分泌性能方面,诱导剂之间没有观察到显著差异,这可能是因为在碳通量限制下发生了共同的诱导机制。酶混合物的特性与生产力无关,而是与底物组成有关。在进料中增加木糖含量的影响最大。它使纤维素酶、内切葡聚糖酶和纤维二糖水解酶的活性降低了 2 倍,β-葡萄糖苷酶的活性降低了 4 倍。相比之下,木聚糖酶的活性增加了 6 倍。因此,在酶混合物中同时具有高β-葡萄糖苷酶和木聚糖酶活性似乎是不相容的。用在生物反应器中进行的四个分批补料培养对酶活性的变化进行了建模和验证。当用非诱导性糖替代高达 75%的诱导剂时,总体酶产量保持在最高水平。
糖底物组成强烈影响里氏木霉在分批补料模式下分泌的纤维素酶混合物的组成。可以使用建模来根据培养物进料溶液的糖组成预测纤维素酶活性,或者调整底物组成以生产所需的酶混合物。