Computational Nanotechnology DETEMA, Facultad de Química, UDELAR, CC 1157, 11800 Montevideo (Uruguay), Fax: (+589) 229241906.
Chemistry. 2013 Nov 11;19(46):15719-25. doi: 10.1002/chem.201302622. Epub 2013 Oct 2.
Herein, by using dispersion-corrected density functional theory, we investigated the Diels-Alder chemistry of pristine and defective graphene. Three dienes were considered, namely 2,3-dimethoxy-1,3-butadiene (DMBD), 9-methylanthracene (9MA), and 9,10-dimethylanthracene (910DMA). The dienophiles that were assayed were tetracyanoethylene (TCNE) and maleic anhydride (MA). When pristine graphene acted as the dienophile, we found that the cycloaddition products were 47-63 kcal mol(-1) less stable than the reactants, thus making the reaction very difficult. The presence of Stone-Wales translocations, 585 double vacancies, or 555-777 reconstructed double vacancies did not significantly improve the reactivity because the cycloaddition products were still located at higher energy than the reactants. However, for the addition of 910DMA to single vacancies, the product showed comparable stability to the separated reactants, whereas for unsaturated armchair edges the reaction was extremely favorable. With regards the reactions with dienophiles, for TCNE, the cycloaddition product was metastable. In the case of MA, we observed a reaction product that was less stable than the reactants by 50 kcal mol(-1) . For the reactions between graphene as a diene and the dienophiles, we found that the most-promising defects were single vacancies and unsaturated armchair edges, because the other three defects were much-less reactive. Thus, we conclude that the reactions with these above-mentioned dienes may proceed on pristine or defective sheets with heating, despite being endergonic. The same statement also applies to the dienophile maleic anhydride. However, for TCNE, the reaction is only likely to occur onto single vacancies or unsaturated armchair edges. We conclude that the dienophile character of graphene is slightly stronger than its behavior as a diene.
在此,我们通过使用色散校正密度泛函理论,研究了原始和缺陷石墨烯的 Diels-Alder 化学反应。考虑了三种二烯,即 2,3-二甲氧基-1,3-丁二烯(DMBD)、9-甲基蒽(9MA)和 9,10-二甲基蒽(910DMA)。所测试的亲二烯体是四氰乙烯(TCNE)和马来酸酐(MA)。当原始石墨烯作为亲二烯体时,我们发现环加成产物比反应物稳定 47-63 kcal/mol,因此反应非常困难。Stone-Wales 迁移、585 个双空位或 555-777 个重构双空位的存在并没有显著提高反应性,因为环加成产物的能量仍然高于反应物。然而,对于单空位上的 910DMA 的加成,产物与分离的反应物具有相当的稳定性,而对于不饱和扶手椅边缘,反应则非常有利。对于与亲二烯体的反应,TCNE 的环加成产物是亚稳的。在 MA 的情况下,我们观察到反应产物比反应物稳定 50 kcal/mol。对于石墨烯作为二烯和亲二烯体之间的反应,我们发现最有前途的缺陷是单空位和不饱和扶手椅边缘,因为其他三种缺陷的反应性要差得多。因此,我们得出结论,尽管这些反应是吸热的,但带有缺陷的石墨烯薄片在加热时可能会与上述二烯发生反应。对于亲二烯体马来酸酐,也是如此。然而,对于 TCNE,反应仅可能发生在单空位或不饱和扶手椅边缘上。我们得出结论,石墨烯的亲二烯体性质略强于其作为二烯的行为。