Suppr超能文献

通过结合动力学和原子力显微镜研究揭示酶促纤维素降解的表面结构动力学。

Surface structural dynamics of enzymatic cellulose degradation, revealed by combined kinetic and atomic force microscopy studies.

机构信息

Institute of Biotechnology and Biochemical Engineering, Graz University of Technology, Austria.

出版信息

FEBS J. 2014 Jan;281(1):275-90. doi: 10.1111/febs.12594. Epub 2013 Dec 10.

Abstract

Highly heterogeneous and usually weakly defined substrate morphologies complicate the study of enzymatic cellulose hydrolysis. The cellulose surface has a non-uniform shape in particular, with consequent impacts on cellulase adsorption and activity. We have therefore prepared a cellulosic model substrate which is shown by atomic force microscopy (AFM) to display a completely smooth surface, the residual squared mean roughness being 10 nm or lower, and applied it for kinetic analysis of cellulase action. The substrate consists of an amorphous cellulose matrix into which variably sized crystalline fibers are distributed in apparently irregular fashion. Its conversion into soluble sugars by Trichoderma sp. cellulase at 50 °C proceeded without apparent limitation up to 70% completion and was paralleled by a steady increase in cellulase adsorption to the cellulose. Individual cellulase components (CBH I, CBH II, EG) also showed strongly enhanced adsorption with progressing cellulose conversion, irrespective of their preference for degrading the amorphous or crystalline substrate parts as revealed by AFM. The specific activity of the adsorbed cellulases, however, decreased concomitantly. Cellulose surface morphologies evolving as a consequence of cellulase action were visualized by AFM. Three-dimensional surface degradation by the cellulases resulted in a large increase in cellulose surface area for enzyme adsorption. However, the decline in enzyme specific activity during conversion was caused by factors other than surface ablation and disruption. Based on kinetic evidence for enzymatic hydrolyses of the smooth-surface model substrate and microcrystalline cellulose (Avicel), we hypothesize that, due to gradual loss of productive dynamics in their interactions with the cellulose surface, individual cellulases get progressively confined to substrate parts where they are no longer optimally active. This eventually leads to an overall slow-down of hydrolysis.

摘要

高度异质且通常定义较弱的基质形态使酶促纤维素水解的研究变得复杂。纤维素表面具有不均匀的形状,这对纤维素酶的吸附和活性有相应的影响。因此,我们制备了一种纤维素模型底物,原子力显微镜(AFM)显示其表面完全光滑,剩余均方根粗糙度为 10nm 或更低,并将其应用于纤维素酶作用的动力学分析。该底物由无定形纤维素基质组成,其中不同大小的结晶纤维以明显不规则的方式分布。在 50°C 下,里氏木霉纤维素酶将其转化为可溶性糖,在 70%的完成度内没有明显的限制,并且伴随着纤维素酶吸附到纤维素上的稳定增加。个别纤维素酶成分(CBH I、CBH II、EG)也表现出强烈的增强吸附作用,随着纤维素转化率的提高,无论它们优先降解无定形或结晶基质部分,这一点通过 AFM 得到了揭示。然而,吸附纤维素酶的比活性随之下降。纤维素酶作用导致的纤维素表面形态通过 AFM 可视化。纤维素酶的三维表面降解导致纤维素表面积增加,有利于酶吸附。然而,在转化过程中,酶比活性的下降不是由表面烧蚀和破坏等因素引起的。基于对光滑表面模型底物和微晶纤维素(Avicel)的酶促水解的动力学证据,我们假设,由于其与纤维素表面相互作用的生产动力学逐渐丧失,个别纤维素酶逐渐局限于它们不再具有最佳活性的底物部分。这最终导致水解整体减缓。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验