Amarasiriwardena Chitra J, Jayawardene Innocent, Lupoli Nicola, Barnes Ramon M, Hernandez-Avila Mauricio, Hu Howard, Ettinger Adrienne S
Department of Environmental Health, Harvard School of Public Health, 665 Huntington Ave, Boston, MA 02115, USA.
University Research Institute for Analytical Chemistry, 85 N. Whitney Street, Amherst, MA 01002, USA.
Anal Methods. 2013;5(7):1676-1681. doi: 10.1039/C3AY26321E.
Measurement of lead in breast milk is an important public health consideration and can be technically quite challenging. The reliable and accurate determination of trace lead in human breast milk is difficult for several reasons including: potential for contamination during sample collection, storage, and analysis; complexities related to the high fat content of human milk; and poor analytic sensitivity at low concentrations. Breast milk lead levels from previous published studies should therefore be reviewed with caution. Due to the difficulty in identifying a method that would successfully digest samples with 100% efficiency, we evaluated three different digestion procedures including: (1) dry ashing in a muffle furnace, (2) microwave oven digestion, and (3) digestion in high pressure asher. High temperature, high pressure asher digestion was selected as the procedure of choice for the breast milk samples. Trace lead analysis was performed using isotope dilution (ID) inductively coupled plasma mass spectrometry (ICP-MS). Measured lead concentrations in breast milk samples ( = 200) from Mexico ranged from 0.2 to 6.7 ng ml. The precision for these measurements ranged from 0.27-7.8% RSD. Use of strict contamination control techniques and of a very powerful digestion procedure, along with an ID-ICP-MS method for lead determination, enables us to measure trace lead levels as low as 0.2 ng ml in milk (instrument detection limit = 0.01 ng ml).
母乳中铅含量的测定是一项重要的公共卫生考量,在技术上颇具挑战性。由于多种原因,可靠且准确地测定人母乳中的痕量铅存在困难,这些原因包括:样品采集、储存和分析过程中存在污染的可能性;与人乳高脂肪含量相关的复杂性;以及低浓度下分析灵敏度较差。因此,对于以往发表研究中的母乳铅含量水平应谨慎审视。由于难以找到一种能以100%效率成功消解样品的方法,我们评估了三种不同的消解程序,包括:(1)在马弗炉中干灰化,(2)微波炉消解,以及(3)在高压灰化器中消解。高温、高压灰化器消解被选为母乳样品的首选程序。痕量铅分析采用同位素稀释(ID)电感耦合等离子体质谱法(ICP-MS)进行。来自墨西哥的母乳样品(n = 200)中测得的铅浓度范围为0.2至6.7 ng/ml。这些测量的精密度范围为相对标准偏差(RSD)0.27 - 7.8%。使用严格的污染控制技术和非常有效的消解程序,以及采用ID-ICP-MS方法测定铅,使我们能够测量母乳中低至0.2 ng/ml的痕量铅水平(仪器检测限 = 0.01 ng/ml)。