Tjhung Katrina F, Burnham Sean, Anany Hany, Griffiths Mansel W, Derda Ratmir
Department of Chemistry, University of Alberta , Edmonton, AB T6G 2G2, Canada.
Anal Chem. 2014 Jun 17;86(12):5642-8. doi: 10.1021/ac500244g. Epub 2014 Jun 3.
Phage-based detection assays have been developed for the detection of viable bacteria for applications in clinical diagnosis, monitoring of water quality, and food safety. The majority of these assays deliver a positive readout in the form of newly generated progeny phages by the bacterial host of interest. Progeny phages are often visualized as plaques, or holes, in a lawn of bacteria on an agar-filled Petri dish; however, this rate-limiting step requires up to 12 h of incubation time. We have previously described an amplification of bacteriophages M13 inside droplets of media suspended in perfluorinated oil; a single phage M13 in a droplet yields 10(7) copies in 3-4 h. Here, we describe that encapsulation of reporter phages, both lytic T4-LacZ and nonlytic M13, in monodisperse droplets can also be used for rapid enumeration of phage. Compartmentalization in droplets accelerated the development of the signal from the reporter enzyme; counting of "positive" droplets yields accurate enumeration of phage particles ranging from 10(2) to 10(6) pfu/mL. For enumeration of T4-LacZ phage, the fluorescent signal appeared in as little as 90 min. Unlike bulk assays, quantification in emulsion is robust and insensitive to fluctuations in environmental conditions (e.g., temperature). Power-free emulsification using gravity-driven flow in the absence of syringe pumps and portable fluorescence imaging solutions makes this technology promising for use at the point of care in low-resource environments. This droplet-based phage enumeration method could accelerate and simplify point-of-care detection of the pathogens for which reporter bacteriophages have been developed.
基于噬菌体的检测方法已被开发用于检测活菌,应用于临床诊断、水质监测和食品安全领域。这些检测方法大多通过目标细菌宿主产生新的子代噬菌体来给出阳性读数。子代噬菌体通常在琼脂平板上的细菌菌苔中呈现为噬菌斑或空洞;然而,这一限速步骤需要长达12小时的孵育时间。我们之前曾描述过在悬浮于全氟油中的培养基液滴内扩增噬菌体M13的方法;一个液滴中的单个噬菌体M13在3 - 4小时内可产生10⁷个拷贝。在此,我们描述了将报告噬菌体(包括裂解性T4 - LacZ和非裂解性M13)封装在单分散液滴中也可用于快速计数噬菌体。液滴中的分隔加速了报告酶信号的产生;对“阳性”液滴进行计数可准确计数10²至10⁶ pfu/mL范围内的噬菌体颗粒。对于T4 - LacZ噬菌体的计数,荧光信号在短短90分钟内就会出现。与批量检测不同,乳液中的定量分析稳健且对环境条件(如温度)的波动不敏感。在没有注射泵和便携式荧光成像解决方案的情况下,利用重力驱动流进行无动力乳化使得该技术有望在资源匮乏环境中的即时检测中得到应用。这种基于液滴的噬菌体计数方法可以加速并简化对已开发出报告噬菌体的病原体的即时检测。