de Blois Erik, Chan Ho Sze, Roy Kamalika, Krenning Eric P, Breeman Wouter A P
Department of Nuclear Medicine, Erasmus MC, 's Gravendijkwal 230, 3015 Rotterdam, The Netherlands.
Department of Chemistry, University of Calcutta, Kolkata, India.
J Radioanal Nucl Chem. 2011;288(1):303-306. doi: 10.1007/s10967-010-0915-8. Epub 2010 Dec 23.
PET with Ga from the TiO- or SnO- based Ge/Ga generators is of increasing interest for PET imaging in nuclear medicine. In general, radionuclidic purity (Ge vs. Ga activity) of the eluate of these generators varies between 0.01 and 0.001%. Liquid waste containing low amounts of Ge activity is produced by eluting the Ge/Ga generators and residues from PET chemistry. Since clearance level of Ge activity in waste may not exceed 10 Bq/g, as stated by European Directive 96/29/EURATOM, our purpose was to reduce Ge activity in solution from >10 kBq/g to <10 Bq/g; which implies the solution can be discarded as regular waste. Most efficient method to reduce the Ge activity is by sorption of TiO or FeO and subsequent centrifugation. The required 10 Bq per mL level of Ge activity in waste was reached by FeO logarithmically, whereas with TiO asymptotically. The procedure with FeO eliminates ≥90% of the Ge activity per treatment. Eventually, to simplify the processing a recirculation system was used to investigate Ge activity sorption on TiO, FeO or Zeolite. Zeolite was introduced for its high sorption at low pH, therefore Ge activity containing waste could directly be used without further interventions. Ge activity containing liquid waste at different HCl concentrations (0.05-1.0 M HCl), was recirculated at 1 mL/min. With Zeolite in the recirculation system, Ge activity showed highest sorption.
基于二氧化钛或二氧化锡的锗/镓发生器产生的含镓正电子发射断层显像剂(PET)在核医学的PET成像中越来越受到关注。一般来说,这些发生器洗脱液的放射性核素纯度(锗与镓的活度)在0.01%至0.001%之间变化。通过洗脱锗/镓发生器以及PET化学过程中的残留物会产生含有少量锗活度的液体废物。如欧洲指令96/29/EURATOM所述,由于废物中锗活度的清除水平不得超过10 Bq/g,我们的目的是将溶液中的锗活度从>10 kBq/g降低到<10 Bq/g;这意味着该溶液可以作为普通废物丢弃。降低锗活度的最有效方法是通过吸附二氧化钛或氧化铁并随后进行离心。通过氧化铁对数方式可达到废物中每毫升所需的10 Bq锗活度水平,而使用二氧化钛则是渐近达到。每次处理时,氧化铁程序可消除≥90%的锗活度。最终,为了简化处理过程,使用了一个再循环系统来研究锗活度在二氧化钛、氧化铁或沸石上的吸附情况。引入沸石是因为它在低pH值下具有高吸附性,因此含锗活度的废物无需进一步处理即可直接使用。不同盐酸浓度(0.05 - 1.0 M HCl)的含锗活度液体废物以1 mL/min的流速进行再循环。在再循环系统中加入沸石后,锗活度显示出最高的吸附率。