Rose G E, Lavin M J, Hitchings R A
Moorfields Eye Hospital, London.
Eye (Lond). 1989;3 ( Pt 5):553-61. doi: 10.1038/eye.1989.87.
One hundred and nineteen eyes with glaucoma were treated by implantation of silicone rubber tubes draining either to encircling inverted gutters (92 eyes) or to integral plates sutured at the equator of the globe. The occurrence of persistent choroidal effusion was related significantly (S less than 0.01) to post-operative hypotony and choroidal haemorrhage appeared to occur during periods of ocular hypotony. This paper describes our surgical modifications to overcome these problems. A one-piece integral tube and plate with a slit-valve mechanism designed to regulate post-operative intraocular pressure had a very variable response in 27 eyes, with mean pressures similar to those after unligated tube and gutters. Ligation of the tube in 34 eyes caused significantly higher mean intraocular pressures on the first two days after surgery than that in 43 eyes without ligation and the incidence of ocular hypotony (less than 7 mmHg) was significantly lower after ligation. However, five eyes with ligated tubes required operative release of the suture because of uncontrollably raised intraocular pressures. Venting of the drainage tube on the anterior chamber side of the occlusive ligation in 15 eyes caused fewer cases of raised post-operative intraocular pressures, but also a moderate increase in the frequency of ocular hypotony. At present a combination of occlusive ligation and a venting stab into the drainage tube in a one-piece tube and plate system appears to be the best design for avoiding short-term ocular hypotony whilst achieving long-term pressure control.
119 只青光眼患眼接受了硅胶管植入治疗,硅胶管引流至环绕的倒置沟槽(92 只眼)或缝合于眼球赤道的整体板。持续性脉络膜渗漏的发生与术后低眼压显著相关(S<0.01),脉络膜出血似乎发生在眼压降低期间。本文描述了我们为克服这些问题所做的手术改进。一种带有用于调节术后眼压的裂隙阀机制的一体式整体管和板在 27 只眼中反应非常多变,平均眼压与未结扎管和沟槽后的眼压相似。34 只眼的硅胶管结扎术后头两天的平均眼压显著高于 43 只未结扎眼,结扎后低眼压(低于 7 mmHg)的发生率显著降低。然而,5 只结扎管的患眼因眼压无法控制地升高而需要手术松解缝线。15 只眼在阻塞性结扎的前房侧对引流管进行穿刺排气导致术后眼压升高的病例较少,但低眼压的频率也有适度增加。目前,在一体式管和板系统中,阻塞性结扎与对引流管进行穿刺排气相结合似乎是避免短期低眼压同时实现长期眼压控制的最佳设计。