Younesi Mousa, Goldberg Victor M, Akkus Ozan
Department of Mechanical and Aerospace Engineering, Case Western Reserve University, Cleveland, OH 44106, USA.
Department of Orthopedics, Case Western Reserve University, Cleveland, OH 44106, USA.
Acta Biomater. 2016 Jan;30:212-221. doi: 10.1016/j.actbio.2015.11.024. Epub 2015 Nov 18.
The unique arcade-like orientation of collagen fibers enables cartilage to bear mechanical loads. In this study continuous-length aligned collagen threads were woven to emulate the interdigitated arcade structure of the cartilage. The weaving pattern provided a macropore network within which micromass cell pellets were seeded to take advantage of mesenchymal condensation driven chondrogenesis. Compression tests showed that the baseline scaffold had a modulus of 0.83±0.39MPa at a porosity of 80%. The modulus of pellet seeded scaffolds increased by 60% to 1.33±0.37MPa after 28days of culture, converging to the modulus of the native cartilage. The scaffolds displayed duress under displacement controlled low-cycle fatigue at 15% strain amplitude such that load reduction stabilized at 8% after 4500 cycles of loading. The woven structure demonstrated a substantial elastic recoil where 40% mechanical strain was close to completely recovered following unloading. A robust chondrogenesis was observed as evidenced by positive staining for GAGs and type II collagen and aggrecan. Dimethyl methylene blue and sircol assays showed GAGs and collagen productions to increase from 3.36±1.24 and 31.46±3.22 at day 3 to 56.61±12.12 and 136.70±12.29μg/μg of DNA at day 28 of culture. This woven collagen scaffold holds a significant potential for cartilage regeneration with shorter in vitro culture periods due to functionally sufficient mechanical robustness at the baseline. In conclusion, the mimicry of cartilage's arcade architecture resulted in substantial improvement of mechanical function while enabling one of the first pellet delivery platforms enabled by a macroporous network.
Mesenchymal condensation is critical for driving chondrogenesis, making high density cell seeding a standard in cartilage tissue engineering. Efforts to date have utilized scaffold free delivery of MSCs in pellet form. This study developed a macroporous scaffold that is fabricated by weaving highly aligned collagen threads. The scaffold can deliver high density cell condensates while providing mechanical stiffness comparable to that of cartilage. The scaffold also mimicked the arcade-like orientation of collagen fibers in cartilage. A highly robust chondrogenesis was observed in this mesenchymal cell pellet delivery system. Baseline mechanical robustness of this scaffold system will enable delivery of cell pellets as early as three days.
胶原纤维独特的类似拱廊的排列方式使软骨能够承受机械负荷。在本研究中,编织连续长度排列的胶原线以模拟软骨的指状交叉拱廊结构。编织图案提供了一个大孔网络,在其中接种微团细胞颗粒,以利用间充质凝聚驱动的软骨生成。压缩试验表明,基线支架在孔隙率为80%时的模量为0.83±0.39MPa。培养28天后,接种颗粒的支架模量增加60%,达到1.33±0.37MPa,接近天然软骨的模量。在15%应变幅度的位移控制低周疲劳下,支架表现出胁迫,以至于在加载4500次循环后,负荷降低稳定在8%。编织结构表现出显著的弹性回缩,卸载后40%的机械应变几乎完全恢复。观察到强大的软骨生成,糖胺聚糖、II型胶原蛋白和聚集蛋白聚糖的阳性染色证明了这一点。二甲基亚甲蓝和Sircol分析表明,培养第3天糖胺聚糖和胶原蛋白产量分别为3.36±1.24和31.46±3.22,培养第28天增加到56.61±12.12和136.70±12.29μg/μg DNA。这种编织胶原支架由于在基线时具有功能上足够的机械强度,在较短的体外培养期内具有软骨再生的巨大潜力。总之,模仿软骨的拱廊结构导致机械功能的显著改善,同时实现了由大孔网络支持的首批颗粒递送平台之一。
间充质凝聚对于驱动软骨生成至关重要,使高密度细胞接种成为软骨组织工程的标准。迄今为止的努力采用了无支架的微团形式的间充质干细胞递送。本研究开发了一种通过编织高度排列的胶原线制成的大孔支架。该支架可以递送高密度细胞凝聚物,同时提供与软骨相当的机械刚度。该支架还模仿了软骨中胶原纤维的类似拱廊的排列方式。在这种间充质细胞颗粒递送系统中观察到了高度强大的软骨生成。该支架系统的基线机械强度将使细胞颗粒最早在三天后就能递送。