Suppr超能文献

改善脊髓损伤患者的从站立到坐下动作

Improving stand-to-sit maneuver for individuals with spinal cord injury.

作者信息

Chang Sarah R, Nandor Mark J, Kobetic Rudi, Foglyano Kevin M, Quinn Roger D, Triolo Ronald J

机构信息

Department of Veterans Affairs, Advanced Platform Technology Center, Louis Stokes Cleveland VA Medical Center, 10701 East Blvd, 151AW/APT, Cleveland, OH, 44106, USA.

Department of Biomedical Engineering, Case Western Reserve University, 10900 Euclid Avenue, Cleveland, OH, 44106, USA.

出版信息

J Neuroeng Rehabil. 2016 Mar 15;13:27. doi: 10.1186/s12984-016-0137-6.

Abstract

BACKGROUND

Users of neuroprostheses employing electrical stimulation (ES) generally complete the stand-to-sit (STS) maneuver with high knee angular velocities, increased upper limb support forces, and high peak impact forces at initial contact with the chair. Controlling the knee during STS descent is challenging in individuals with spinal cord injury (SCI) due to the decreasing joint moment available with increased knee angle in response to ES.

METHODS

The goal of this study was to investigate the effects of incorporating either (1) a coupling mechanism that coordinates hip and knee flexion or (2) a mechanism that damps knee motion to keep the knee angular velocity constant during the STS transition. The coupling and damping were achieved by hydraulic orthotic mechanisms. Two subjects with SCI were enrolled and each served as their own controls when characterizing the performance of each mechanism during STS as compared to stimulation alone. Outcome measures such as hip-knee angle, knee angular velocity, upper limb support force, and impact force were analyzed to determine the effectiveness of the two mechanisms in providing controlled STS.

RESULTS

The coordination between the hip and knee joints improved with each orthotic mechanism. The damping and hip-knee coupling mechanisms caused the hip and knee joint ratios of 1:1.1 and 1:0.99, respectively, which approached the 1:1 coordination ratio observed in nondisabled individuals during STS maneuver. The knee damping mechanism provided lower (p < 0.001) and a more constant knee angular velocity than the hip-knee coupling mechanism over the knee range of motion. Both the coupling and damping mechanisms were similarly effective at reducing upper limb support forces by 70 % (p < 0.001) and impact force by half (p ≤ 0.001) as compared to sitting down with stimulation alone.

CONCLUSIONS

Orthoses imposing simple kinematic constraints, such as 1:1 hip-knee coupling or knee damping, can normalize upper limb support forces, peak knee angular velocity, and peak impact force during the STS maneuvers.

摘要

背景

采用电刺激(ES)的神经假体使用者在完成从站立到坐下(STS)动作时,通常膝关节角速度较高,上肢支撑力增加,且初始接触椅子时峰值冲击力较大。由于脊髓损伤(SCI)患者在电刺激作用下,随着膝关节角度增加关节力矩减小,因此在STS下降过程中控制膝关节具有挑战性。

方法

本研究的目的是探究纳入以下两种机制的效果:(1)一种协调髋关节和膝关节屈曲的耦合机制;(2)一种在STS转换过程中抑制膝关节运动以保持膝关节角速度恒定的机制。通过液压矫形器机制实现耦合和阻尼。招募了两名脊髓损伤患者,在与单独刺激相比评估每种机制在STS过程中的性能时,每位患者均作为自身对照。分析诸如髋膝角度、膝关节角速度、上肢支撑力和冲击力等结果指标,以确定这两种机制在提供可控STS方面的有效性。

结果

每种矫形器机制均改善了髋关节和膝关节之间的协调性。阻尼和髋膝耦合机制分别使髋关节和膝关节的比例达到1:1.1和1:0.99,接近非残疾个体在STS动作中观察到的1:1协调比例。在膝关节运动范围内,膝关节阻尼机制比髋膝耦合机制提供更低(p < 0.001)且更恒定的膝关节角速度。与单独刺激下坐下相比,耦合和阻尼机制在将上肢支撑力降低70%(p < 0.001)和将冲击力减半(p ≤ 0.001)方面同样有效。

结论

施加简单运动学约束的矫形器,如1:1髋膝耦合或膝关节阻尼,可使STS动作期间的上肢支撑力、膝关节峰值角速度和峰值冲击力正常化。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/e8df/4793745/5e1969d4f541/12984_2016_137_Fig1_HTML.jpg

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验