Suppr超能文献

股骨近端生长改良:螺钉、钢板及钻头对髋关节不对称生长的影响。

Proximal Femoral Growth Modification: Effect of Screw, Plate, and Drill on Asymmetric Growth of the Hip.

作者信息

d'Heurle Albert, McCarthy James, Klimaski David, Stringer Keith

机构信息

Department of Orthopaedic Surgery, University of Cincinnati.

Division of Orthopedics.

出版信息

J Pediatr Orthop. 2018 Feb;38(2):100-104. doi: 10.1097/BPO.0000000000000771.

Abstract

BACKGROUND

Guided growth has long been used in the lower extremities but has not been applied to varus or valgus deformity in the hip, as may occur in children with cerebral palsy or developmental dysplasia of the hip. The purpose of this study was to determine if screw, plate, or drilling techniques decreased the femoral neck-shaft angle (NSA) and articular trochanteric disease (ATD), as well as describe growth plate structural changes with each method.

METHODS

Twelve 8-week-old lambs underwent proximal femoral hemiepiphysiodesis (IACUC approved) using either a screw (n=4), plate (n=4), or drilling procedure (n=4). Postoperative time was 6 months. Radiographs taken after limb harvest were used to measure NSA and ATD. Differences between treated and control sides were determined by 1-tailed paired t tests and Bonferroni (α=0.05/3). Histology was obtained for 1 limb pair per group. Proximal femurs were cut in midcoronal plane and the longitudinal growth plates were examined for structural changes.

RESULTS

The mean NSA measured 7 degrees less than controls in this model using the screw technique, and this difference was statistically significant. Differences between the control and the treated groups did not reach statistical significance for either the plate or the drill group. Differences in ATD were not statistically significant, although there was a trend for larger ATD measurements using the screw technique. Histologically, physeal changes were observed on the operative sides in screw and plate specimens, but not drill specimens, compared with contralateral sham control. The screw specimen exhibited the most severe changes, with growth plate closure over half the section. The plate specimen showed focal loss of the physis across the section, but with no evidence of closure.

CONCLUSIONS

This study builds on previous work that indicates screw hemiepiphysiodesis can effectively alter the shape of the proximal femur, and result in a lower neck-shaft ankle (or lesser valgus). This study suggests that implantation of a screw is likely to be more effective than a plate or drilling procedure in decreasing the NSA in skeletally immature hips.

CLINICAL SIGNIFICANCE

If further preclinical, and later clinical, studies demonstrate reproducible efficacy, guided growth of the proximal femur may eventually become a viable option for treatment or prevention of hip deformity in select patients.

摘要

背景

引导性生长技术长期以来一直应用于下肢,但尚未应用于髋关节内翻或外翻畸形,如脑瘫患儿或发育性髋关节发育不良患儿可能出现的情况。本研究的目的是确定螺钉、钢板或钻孔技术是否能减小股骨颈干角(NSA)和关节转子疾病(ATD),并描述每种方法对生长板结构的改变。

方法

12只8周龄羔羊接受近端股骨半骨骺阻滞术(经机构动物护理和使用委员会批准),其中4只采用螺钉技术,4只采用钢板技术,4只采用钻孔技术。术后时间为6个月。肢体切除后拍摄的X线片用于测量NSA和ATD。治疗侧与对照侧的差异通过单尾配对t检验和Bonferroni检验(α=0.05/3)确定。每组取一对肢体进行组织学检查。将近端股骨在中冠状面切开,检查纵向生长板的结构变化。

结果

在该模型中,采用螺钉技术时,平均NSA比对照组小7度,且差异具有统计学意义。钢板组和钻孔组的对照组与治疗组之间的差异未达到统计学意义。ATD的差异无统计学意义,尽管采用螺钉技术时ATD测量值有增大的趋势。组织学上,与对侧假手术对照组相比,螺钉和钢板标本的手术侧生长板出现了变化,但钻孔标本未出现变化。螺钉标本变化最为严重,生长板在超过一半的截面处闭合。钢板标本显示整个截面的生长板局部缺失,但无闭合迹象。

结论

本研究基于先前的工作,表明螺钉半骨骺阻滞术可有效改变近端股骨的形状,并导致颈干角减小(或外翻程度减轻)。本研究表明,在骨骼未成熟的髋关节中,植入螺钉在减小NSA方面可能比钢板或钻孔技术更有效。

临床意义

如果进一步的临床前及后续临床研究证明其疗效可重复,近端股骨的引导性生长最终可能成为特定患者治疗或预防髋关节畸形的可行选择。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验