Bazalova-Carter Magdalena, Weil Michael D, Breitkreutz Dylan Yamabe, Wilfley Brian P, Graves Edward E
Department of Physics and Astronomy, University of Victoria, PO Box 1700 ST CSC, Victoria, BC, V8W 2Y2, Canada.
Sirius Medicine LLC, Box 414, Half Moon Bay, CA, 94019, USA.
Med Phys. 2017 Feb;44(2):597-607. doi: 10.1002/mp.12047. Epub 2017 Jan 30.
Radiation therapy to deep-seated targets is typically delivered with megavoltage x-ray beams generated by medical linear accelerators or Co sources. Here, we used computer simulations to design and optimize a lower energy kilovoltage x-ray source generating acceptable dose distributions to a deep-seated target.
The kilovoltage arc therapy (KVAT) x-ray source was designed to treat a 4-cm diameter target located at a 10-cm depth in a 40-cm diameter homogeneous cylindrical phantom. These parameters were chosen as an example of a clinical scenario for testing the performance of the kilovoltage source. A Monte Carlo (MC) model of the source was built in the EGSnrc/BEAMnrc code and source parameters, such as beam energy, tungsten anode thickness, beam filtration, number of collimator holes, collimator hole size and thickness, and source extent were varied. Dose to the phantom was calculated in the EGSnrc/DOSXYZnrc code for varying treatment parameters, such as the source-to-axis distance and the treatment arc angle. The quality of dose distributions was quantified by means of target-to-skin ratio and dose output expressed in D (50% isodose line) for a 30-min irradiation in the homogeneous phantom as well as a lung phantom. Additionally, a patient KVAT dose distribution to a left pararenal lesion (~1.6 cm in diameter) was calculated and compared to a 15 MV volumetric modulated arc therapy (VMAT) plan.
In the design of the KVAT x-ray source, the beam energy, beam filtration, collimator hole size, source-to-isocenter distance, and treatment arc had the largest effect on the source output and the quality of dose distributions. For the 4-cm target at 10-cm depth, the optimized KVAT dose distribution generated a conformal plan with target-to-skin ratio of 5.1 and D in 30 min of 24.1 Gy in the homogeneous phantom. In the lung phantom, a target-to-skin ratio of 7.5 and D in 30 min of 25.3 Gy were achieved. High dose conformity of the 200 kV KVAT left pararenal plan was comparable to the 15 MV VMAT plan. The volume irradiated to at least 10% (<240 cGy) of the prescription dose was 2.2 × larger in the 200 kV KVAT plan than in the 15 MV VMAT plan, but considered clinically insignificant.
This study demonstrated that conformal treatments of deep-seated targets were achievable with kilovoltage x-rays with dose distributions comparable to MV beams. However, due to the larger volumes irradiated to clinically tolerated low doses, KVAT x-ray source usage for deep-seated lesions will be further evaluated to determine optimal target size.
对深部靶区进行放射治疗通常使用医用直线加速器或钴源产生的兆伏级X射线束。在此,我们使用计算机模拟来设计和优化一种低能量千伏级X射线源,使其能为深部靶区产生可接受的剂量分布。
千伏级弧形治疗(KVAT)X射线源被设计用于治疗位于直径40 cm均匀圆柱形模体中深度为10 cm处、直径4 cm的靶区。选择这些参数作为测试千伏级源性能的临床场景示例。在EGSnrc/BEAMnrc代码中构建了该源的蒙特卡罗(MC)模型,并改变了源参数,如束流能量、钨阳极厚度、束流过滤、准直器孔数量、准直器孔尺寸和厚度以及源范围。在EGSnrc/DOSXYZnrc代码中针对不同的治疗参数(如源轴距和治疗弧角)计算模体中的剂量。通过靶区与皮肤剂量比以及在均匀模体和肺部模体中30分钟照射的D(50%等剂量线)表示的剂量输出对剂量分布质量进行量化。此外,计算了患者KVAT对左侧肾旁病变(直径约1.6 cm)的剂量分布,并与15 MV容积调强弧形治疗(VMAT)计划进行比较。
在KVAT X射线源的设计中,束流能量、束流过滤、准直器孔尺寸、源到等中心距离和治疗弧对源输出和剂量分布质量影响最大。对于深度为10 cm处的4 cm靶区,优化后的KVAT剂量分布在均匀模体中产生了适形计划,靶区与皮肤剂量比为5.1,30分钟内的D为24.1 Gy。在肺部模体中,靶区与皮肤剂量比为7.5,30分钟内的D为25.3 Gy。200 kV KVAT左侧肾旁计划的高剂量适形性与15 MV VMAT计划相当可比。200 kV KVAT计划中接受至少10%(<240 cGy)处方剂量照射的体积比15 MV VMAT计划大2.2倍,但认为在临床上无显著意义。
本研究表明,千伏级X射线可实现对深部靶区的适形治疗,其剂量分布与兆伏级束流相当。然而,由于照射到临床可耐受低剂量的体积较大,将进一步评估KVAT X射线源用于深部病变的情况,以确定最佳靶区大小。