Cardiovascular Medicine, The Sakakibara Heart Institute of Okayama.
Department of Cardiovascular Medicine, Tokyo Medical and Dental University.
Circ J. 2017 Oct 25;81(11):1730-1735. doi: 10.1253/circj.CJ-16-1291. Epub 2017 May 31.
As mitral valve (MV) repair for Barlow's disease remains surgically challenging, it is important to distinguish Barlow's disease from fibroelastic deficiency (FED) preoperatively. We hypothesized that the prolapse volume to prolapse height ratio (PV-PH ratio) may be useful to differentiate Barlow's disease and FED.Methods and Results:In 76 patients with MV prolapse who underwent presurgical transesophageal echocardiography, the 3D MV morphology was quantified: 19 patients were diagnosed with Barlow's disease and 57 with FED. The patients with Barlow's disease had greater prolapse volume and height than the patients with FED, as well as greater PV-PH ratio (0.61±0.35 vs. 0.17±0.10, P<0.001). Receiver-operating characteristic analysis revealed that with a cutoff value of 0.27, the PV-PH ratio differentiated Barlow's disease from FED with 84.2% sensitivity and 84.2% specificity. Net reclassification improvement showed that the differentiating ability of the PV-PH ratio was significantly superior to prolapse volume (1.30, P<0.001). After being adjusted by each of prolapse volume and height, annular area and shape, and the number of prolapsed segments, the PV-PH ratio had an independent association with Barlow's disease.
The PV-PH ratio was able to differentiate Barlow's disease from FED with high accuracy. 3D quantification including this value should be performed before MV repair.
由于巴氏二尖瓣(MV)病变的修复仍然具有挑战性,因此术前区分巴氏病和纤维弹性减退(FED)非常重要。我们假设脱垂容积与脱垂高度比值(PV-PH 比值)可能有助于区分巴氏病和 FED。
在 76 例行 MV 脱垂术前经食管超声心动图检查的患者中,对 MV 形态进行了 3D 量化:19 例患者被诊断为巴氏病,57 例患者为 FED。巴氏病患者的脱垂容积和高度均大于 FED 患者,且 PV-PH 比值也更大(0.61±0.35 比 0.17±0.10,P<0.001)。受试者工作特征分析显示,当截断值为 0.27 时,PV-PH 比值对巴氏病的诊断具有 84.2%的敏感性和 84.2%的特异性。净重新分类改善表明,PV-PH 比值的鉴别能力明显优于脱垂容积(1.30,P<0.001)。在调整了脱垂容积和高度、瓣环面积和形状以及脱垂节段数后,PV-PH 比值与巴氏病仍具有独立相关性。
PV-PH 比值能够准确地区分巴氏病和 FED。在进行 MV 修复之前,应进行包括该值的 3D 定量分析。