D'Amico Moreno, Kinel Edyta, Roncoletta Piero
SMART Lab (Skeleton Movement Analysis & Advanced Rehabilitation Technologies) Bioengineering & Biomedicine Company Srl, Pescara, Italy.
Department of Rheumatology and Rehabilitation, Clinic of Rehabilitation, University of Medical Sciences, Poznan, Poland.
PLoS One. 2017 Jun 22;12(6):e0179619. doi: 10.1371/journal.pone.0179619. eCollection 2017.
Observational cross-sectional study. The current study aims to yield normative data: i.e., the physiological standard for 30 selected quantitative 3D parameters that accurately capture and describe a full-skeleton, upright-standing attitude. Specific and exclusive consideration was given to three distinct categories: postural, spine morphology and pelvic parameters. To capture such 3D parameters, the authors selected a non-ionising 3D opto-electronic stereo-photogrammetric approach. This required the identification and measurement of 27 body landmarks, each specifically tagged with a skin marker. As subjects for the measurement of these parameters, a cohort of 124 asymptomatic young adult volunteers was recruited. All parameters were identified and measured within this group. Postural and spine morphology data have been compared between genders. In this regard, only five statistically significant differences were found: pelvis width, pelvis torsion, the "lumbar" lordosis angle value, the lumbar curve length, and the T12-L5 anatomically-bound lumbar angle value. The "thoracic" kyphosis mean angle value was the same in both sexes and, even if, derived from skin markers placed on spinous processes it resulted in perfect agreement with the X-ray based literature. As regards lordosis, a direct comparison was more difficult because methods proposed in the literature differ as to the number and position of vertebrae under consideration, and their related angle values. However, when the L1 superior-L5 inferior end plate Cobb angle was considered, these results aligned strongly with the existing literature. Asymmetry was a standard postural-spinal feature for both sexes. Each subject presented some degree of leg length discrepancy (LLD) with μ = 9.37mm. This was associated with four factors: unbalanced posture and/or underfoot loads, spinal curvature in the frontal plane, and pelvis torsion. This led to the additional study of the effect of LLD equalisation influence on upright posture, relying on a sub-sample of 100 subjects (51 males, 49 females). As a result of the equalisation, about 82% of this sub-sample showed improvement in standing posture, mainly in the frontal plane; while in the sagittal plane less than 1/3 of the sub-sample showed evidence of change in spinal angles. A significant variation was found in relation to pelvis torsion: 46% of subjects showed improvement, 49% worsening. The method described in study presents several advantages: non-invasive aspect; relatively short time for a complete postural evaluation with many clinically useful 3D and 2D anatomical/biomechanical/clinical parameters; analysis of real neutral unconstrained upright standing posture.
观察性横断面研究。本研究旨在得出规范性数据,即30个选定的定量三维参数的生理标准,这些参数能准确捕捉并描述全骨骼直立姿势。研究特别且专门考虑了三个不同类别:姿势、脊柱形态和骨盆参数。为获取此类三维参数,作者选择了一种非电离的三维光电立体摄影测量方法。这需要识别并测量27个身体标志点,每个标志点都用皮肤标记物专门标记。作为测量这些参数的对象,招募了124名无症状的年轻成年志愿者。在这个群体中对所有参数进行了识别和测量。对姿势和脊柱形态数据进行了性别间比较。在这方面,仅发现五个具有统计学意义的差异:骨盆宽度、骨盆扭转、“腰椎”前凸角值、腰椎曲线长度以及T12 - L5解剖学界定的腰椎角值。“胸椎”后凸平均角值在两性中相同,并且即使是从置于棘突上的皮肤标记物得出的,也与基于X射线的文献结果完全一致。至于前凸,由于文献中提出的方法在考虑的椎骨数量和位置及其相关角度值方面存在差异,所以进行直接比较更为困难。然而,当考虑L1上 - L5下终板Cobb角时,这些结果与现有文献高度一致。不对称是两性的标准姿势 - 脊柱特征。每个受试者都存在一定程度的腿长差异(LLD),均值为9.37毫米。这与四个因素有关:姿势和/或足底负荷不平衡、额平面脊柱侧弯以及骨盆扭转。这导致了对腿长差异均衡化对直立姿势影响的进一步研究,该研究基于100名受试者(51名男性,49名女性)的子样本。均衡化的结果是,该子样本中约82%的人站立姿势有所改善,主要是在额平面;而在矢状平面,不到1/3的子样本显示脊柱角度有变化迹象。在骨盆扭转方面发现了显著差异:46%的受试者有所改善,49%恶化。本研究中描述的方法具有几个优点:非侵入性;用许多临床有用的三维和二维解剖学/生物力学/临床参数进行完整姿势评估所需时间相对较短;对真实的中立无约束直立姿势进行分析。