a Department of Chemistry and Materials Engineering, Faculty of Chemistry, Materials and Bioengineering , Kansai University , Suita-shi , Japan.
J Biomater Sci Polym Ed. 2017 Dec;28(17):2021-2033. doi: 10.1080/09205063.2017.1366251. Epub 2017 Aug 17.
In this study, we propose a new polymer substrate that is able to covalently couple intended proteins and reduce nonspecific protein fouling. Poly[2-methacryloyloxyethyl phosphorylcholine (MPC)-ran-N-methacryloyl-(L)-tyrosinemethylester (MAT)] [P(MPC/MAT)] was synthesized by free-radical polymerization. The photooxidation of the MAT unit in the copolymer was observed under ultraviolet (UV) light at 254 nm. P(MPC/MAT) was spin-coated on silicon (Si) and gold substrates. Without UV irradiation of the polymer-coated surface, P(MPC/MAT) physisorbed on the substrates, and the thickness of the polymer layer was less than 10 nm, regardless of the polymer concentration in the coating solution. In contrast, when the polymer-coated surface was irradiated with UV light, the thickness of the polymer layer could be controlled by changing the polymer concentration of the coating solution. Competitive protein adsorption on P(MPC/MAT) was studied. Bovine serum albumin was first contacted with the surface and later challenged with bovine fibrinogen. On bare gold and Si substrates, a large amount of albumin was adsorbed, and the competitive adsorption of albumin and fibronectin was observed. In contrast, the non-UV-irradiated P(MPC/MAT) surface effectively reduced protein adsorption. Interestingly, on the UV-irradiated P(MPC/MAT) surface, the primary protein preferably bonded, and significantly less secondary protein was adsorbed compared to primary protein. Cell adhesion was also tested on the substrate to clarify the effects of proteins existing on the substrates. On the bare Si surface, many adherent cells were observed, regardless of the protein pretreatment. On the non-UV-irradiated P(MPC/MAT) surface, cell adhesion was effectively reduced along with protein adsorption. Cell adhesion on the UV-irradiated P(MPC/MAT) surface depended strongly on the type of protein that was initially in contact with the surface. We concluded that the desired proteins could be immobilized on the photo-activated P(MPC/MAT) surface while preserving their function. Moreover, competitive protein exchange and multilayer adsorption hardly occurred on the surface.
在这项研究中,我们提出了一种新的聚合物基底,能够共价偶联目的蛋白并减少非特异性蛋白污染。通过自由基聚合合成了聚[2-(甲基丙烯酰氧基)乙基磷酸胆碱(MPC)-ran-N-(甲基丙烯酰基)-(L)-酪氨酸甲酯(MAT)][P(MPC/MAT)]。在 254nm 的紫外(UV)光下观察到共聚物中 MAT 单元的光氧化。将 P(MPC/MAT)旋涂在硅(Si)和金基底上。在未对聚合物涂覆表面进行 UV 照射的情况下,P(MPC/MAT)在基底上物理吸附,并且聚合物层的厚度小于 10nm,无论涂覆溶液中的聚合物浓度如何。相比之下,当用 UV 光照射聚合物涂覆表面时,可以通过改变涂覆溶液中的聚合物浓度来控制聚合物层的厚度。研究了 P(MPC/MAT)上的竞争蛋白吸附。首先将牛血清白蛋白与表面接触,然后用牛纤维蛋白原进行挑战。在裸金和 Si 基底上,大量白蛋白被吸附,并且观察到白蛋白和纤维连接蛋白的竞争吸附。相比之下,未经 UV 照射的 P(MPC/MAT)表面有效地减少了蛋白吸附。有趣的是,在 UV 照射的 P(MPC/MAT)表面上,首选的蛋白质结合,与首选蛋白质相比,吸附的次要蛋白质显著减少。还在基底上测试了细胞黏附,以阐明存在于基底上的蛋白质的影响。在裸 Si 表面上,无论蛋白质预处理如何,都观察到许多附着的细胞。在未经 UV 照射的 P(MPC/MAT)表面上,随着蛋白吸附,细胞黏附被有效降低。在 UV 照射的 P(MPC/MAT)表面上的细胞黏附强烈依赖于最初与表面接触的蛋白质的类型。我们得出结论,能够在保留其功能的同时将所需的蛋白质固定在光激活的 P(MPC/MAT)表面上。此外,表面上几乎不会发生竞争蛋白交换和多层吸附。