Wang Haofeng, Chen Shudong, Zhang Shuang, Yuan Zhiwen, Zhang Haiyang, Fang Dong, Zhu Jun
College of Electronic Science and Engineering, Jilin University, Changchun 130012, China.
Science and Technology on Near-Surface Detection Laboratory, Wuxi 214035, China.
Sensors (Basel). 2017 Nov 17;17(11):2651. doi: 10.3390/s17112651.
Portable transient electromagnetic (TEM) systems can be well adapted to various terrains, including mountainous, woodland, and other complex terrains. They are widely used for the detection of unexploded ordnance (UXO). As the core component of the portable TEM system, the sensor is constructed with a transmitting coil and a receiving coil. Based on the primary field of the transmitting coil and internal noise of the receiving coil, the design and testing of such a sensor is described in detail. Results indicate that the primary field of the transmitting coil depends on the diameter, mass, and power of the coil. A higher mass-power product and a larger diameter causes a stronger primary field. Reducing the number of turns and increasing the clamp voltage reduces the switch-off time of the transmitting current effectively. Increasing the cross-section of the wire reduces the power consumption, but greatly increases the coil's weight. The study of the receiving coil shows that the internal noise of the sensor is dominated by the thermal noise of the damping resistor. Reducing the bandwidth of the system and increasing the size of the coil reduces the internal noise effectively. The cross-sectional area and the distance between the sections of the coil have little effect on the internal noise. A less damped state can effectively reduce signal distortion. Finally, a portable TEM sensor with both a transmitting coil (constructed with a diameter, number of turns, and transmitting current of 0.5 m, 30, and 5 A, respectively) and a receiving coil (constructed with a length and resonant frequency of 5.6 cm and 50 kHz, respectively) was built. The agreement between experimental and calculated results confirms the theory used in the sensor design. The responses of an 82 mm mortar shell at different distances were measured and inverted by the differential evolution (DE) algorithm to verify system performance. Results show that the sensor designed in this study can not only detect the 82 mm mortar shell within 1.2 m effectively but also locate the target precisely.
便携式瞬变电磁(TEM)系统能够很好地适应各种地形,包括山区、林地和其他复杂地形。它们被广泛用于未爆弹药(UXO)的探测。作为便携式TEM系统的核心部件,传感器由发射线圈和接收线圈构成。基于发射线圈的一次场和接收线圈的内部噪声,详细描述了这种传感器的设计与测试。结果表明,发射线圈的一次场取决于线圈的直径、质量和功率。更高的质量功率乘积和更大的直径会产生更强的一次场。减少匝数并提高钳位电压可有效缩短发射电流的关断时间。增加导线的横截面积可降低功耗,但会大大增加线圈的重量。对接收线圈的研究表明,传感器的内部噪声主要由阻尼电阻的热噪声主导。减小系统带宽并增加线圈尺寸可有效降低内部噪声。线圈的横截面积和各部分之间的距离对内部噪声影响很小。较小的阻尼状态可有效减少信号失真。最后,构建了一个便携式TEM传感器,其发射线圈(直径、匝数和发射电流分别为0.5 m、30和5 A)和接收线圈(长度和谐振频率分别为5.6 cm和50 kHz)。实验结果与计算结果的一致性证实了传感器设计中所采用的理论。通过差分进化(DE)算法测量并反演了82毫米迫击炮弹在不同距离处的响应,以验证系统性能。结果表明,本研究设计的传感器不仅能够有效探测1.2米范围内的82毫米迫击炮弹,还能精确地定位目标。