Capron Odile, Gopalakrishnan Rahul, Jaguemont Joris, Van Den Bossche Peter, Omar Noshin, Van Mierlo Joeri
Mobility Logistics and Automotive Technology Research Centre (MOBI), Department of Electrical Engineering and Energy Technology (ETEC), Vrije Universiteit Brussel (VUB), 1050 Elsene, Belgium.
Materials (Basel). 2018 Jan 23;11(2):176. doi: 10.3390/ma11020176.
This paper examines the impact of the characterisation technique considered for the determination of the L i + solid state diffusion coefficient in uncycled as in cycled Nickel Manganese Cobalt oxide (NMC) electrodes. As major characterisation techniques, Cyclic Voltammetry (CV), Galvanostatic Intermittent Titration Technique (GITT) and Electrochemical Impedance Spectroscopy (EIS) were systematically investigated. L i + diffusion coefficients during the lithiation process of the uncycled and cycled electrodes determined by CV at 3.71 V are shown to be equal to 3 . 48 × 10 - 10 cm 2 ·s - 1 and 1 . 56 × 10 - 10 cm 2 ·s - 1 , respectively. The dependency of the L i + diffusion with the lithium content in the electrodes is further studied in this paper with GITT and EIS. Diffusion coefficients calculated by GITT and EIS characterisations are shown to be in the range between 1 . 76 × 10 - 15 cm 2 ·s - 1 and 4 . 06 × 10 - 12 cm 2 ·s - 1 , while demonstrating the same decreasing trend with the lithiation process of the electrodes. For both electrode types, diffusion coefficients calculated by CV show greater values compared to those determined by GITT and EIS. With ageing, CV and EIS techniques lead to diffusion coefficients in the electrodes at 3.71 V that are decreasing, in contrast to GITT for which results indicate increasing diffusion coefficient. After long-term cycling, ratios of the diffusion coefficients determined by GITT compared to CV become more significant with an increase about 1 order of magnitude, while no significant variation is seen between the diffusion coefficients calculated from EIS in comparison to CV.
本文研究了用于测定未循环及循环的镍锰钴氧化物(NMC)电极中Li⁺固态扩散系数的表征技术的影响。作为主要的表征技术,系统地研究了循环伏安法(CV)、恒电流间歇滴定技术(GITT)和电化学阻抗谱(EIS)。通过CV在3.71 V下测定的未循环和循环电极在锂化过程中的Li⁺扩散系数分别显示为3.48×10⁻¹⁰ cm²·s⁻¹和1.56×10⁻¹⁰ cm²·s⁻¹。本文利用GITT和EIS进一步研究了电极中Li⁺扩散与锂含量的关系。通过GITT和EIS表征计算得到的扩散系数显示在1.76×10⁻¹⁵ cm²·s⁻¹至4.06×10⁻¹² cm²·s⁻¹范围内,同时表明随着电极锂化过程呈现相同的下降趋势。对于两种电极类型,通过CV计算得到的扩散系数比通过GITT和EIS测定的值更大。随着老化,CV和EIS技术导致3.71 V下电极中的扩散系数下降,而GITT的结果表明扩散系数增加。长期循环后,GITT测定的扩散系数与CV测定的扩散系数之比增加约1个数量级,变得更加显著,而与CV相比,EIS计算的扩散系数之间没有明显变化。