Cheung Jason Pui Yin, Cheung Prudence Wing Hang, Cheung Amy Yim Ling, Lui Darren, Cheung Kenneth M C
Department of Orthopaedics and Traumatology, The University of Hong Kong, 5/F Professorial Block, Queen Mary Hospital, Pokfulam, Hong Kong SAR, China.
Eur Spine J. 2018 Jun;27(6):1365-1374. doi: 10.1007/s00586-018-5533-0. Epub 2018 Feb 28.
To compare the clinical and radiological outcomes between skipped-level and all-level plating for cervical laminoplasty.
Patients with cervical spondylotic myelopathy (CSM) treated by open-door laminoplasty with minimum 2-year postoperative follow-up were included. All patients had opening from C3-6 or C3-7 and were divided into skipped-level or all-level plating groups. Japanese Orthopaedic Association (JOA) scores and canal measurements were obtained preoperatively, immediate (within 1 week) postoperatively, and at 2, 6 weeks, 3, 6 and 12 months postoperatively. Paired t test was used for comparative analysis. Receiver operating characteristic analysis was used to determine the canal expansion cutoff for spring-back closure.
A total of 74 subjects were included with mean age of 66.1 ± 11.3 years at surgery. Of these, 32 underwent skipped-level plating and 42 underwent all-level plating. No significant differences were noted between the two groups at baseline and follow-up. Spring-back closure was observed in up to 50% of the non-plated levels within 3 months postoperatively. The cutoff for developing spring-back closure was 7 mm canal expansion for C3-6. No differences were observed in JOA scores and recovery rates between the two groups. None of the patients with spring-back required reoperation.
There were no significant differences between skipped-level and all-level plating in terms of JOA or recovery rate, and canal diameter differences. This has tremendous impact on saving costs in CSM management as up to two plates per patient undergoing a standard C3-6 laminoplasty may be omitted instead of four plates to every level to achieve similar clinical and radiological outcomes.
III. These slides can be retrieved under Electronic Supplementary Material.
比较颈椎椎板成形术跳跃节段固定与全节段固定的临床和影像学结果。
纳入接受开门式椎板成形术且术后随访至少2年的脊髓型颈椎病(CSM)患者。所有患者均在C3 - 6或C3 - 7节段进行开门操作,并分为跳跃节段固定组或全节段固定组。在术前、术后即刻(1周内)、术后2周、6周、3个月、6个月和12个月时获取日本骨科协会(JOA)评分和椎管测量数据。采用配对t检验进行对比分析。采用受试者工作特征分析确定回弹闭合的椎管扩大临界值。
共纳入74例受试者,手术时平均年龄为66.1±11.3岁。其中,32例行跳跃节段固定,42例行全节段固定。两组在基线和随访时均未观察到显著差异。术后3个月内,高达50%的未固定节段出现回弹闭合。C3 - 6节段发生回弹闭合的临界值为椎管扩大7mm。两组之间在JOA评分和恢复率方面未观察到差异。所有出现回弹的患者均无需再次手术。
跳跃节段固定与全节段固定在JOA评分、恢复率和椎管直径差异方面均无显著差异。这对脊髓型颈椎病的治疗成本节约具有巨大影响,因为对于接受标准C3 - 6椎板成形术的患者,每位患者最多可省略两块钢板,而不是每个节段四块钢板,以获得相似的临床和影像学结果。
III。这些幻灯片可在电子补充材料中获取。