Department of Orthopedic Surgery, Chung General Hospital, 76 Sujeong-ro, Sujeong-gu, Seongnam-si, Gyeonggi-do, 13316, South Korea.
Catholic Institute of Applied Anatomy / Department of Anatomy, College of Medicine, The Catholic University of Korea, 222 Banpo-daero, Seocho-gu, Seoul, 06591, South Korea.
BMC Musculoskelet Disord. 2019 Aug 28;20(1):386. doi: 10.1186/s12891-019-2771-1.
This study evaluated the technical adequacy of trans-articular sacroiliac joint (SIJ) fusion using three screws for non-traumatic SIJ pain, considering different grades of sacral dysplasia.
Cadaveric CT data of unilateral sacropelvic complexes for 72 individuals (53.4 ± 8.4 years) were selected. A 3D model was reformatted into the plain lateral radiograph to mark the articular surface of the SIJ. Subjects were classified into dysplastic (DYS) and non-dysplastic sacrum (NDS) groups. Proximal (PS), middle (MS), and distal screws (DS) with 10-mm diameter were virtually introduced to the iliac bone and the SIJ on the lateral image with a 5-mm safety margin. On a corresponding axial image, each screw was advanced vertically to the sagittal plane with the same safety margin. The entry points for each screw to the endplate of S1 (S2) and to the corresponding anterior sacral margin on the lateral image were measured, along with the maximal screw lengths on the axial image. Whether each screw passed through the SIJ was determined. Different types of sacral dysplasia and screws were compared statistically.
Thirty-eight (26.4%) cases were DYS, and 106 (73.6%) were NDS. The entry points of all screws were significantly more distal in DYS than in NDS groups. The PS and MS screw lengths differed significantly between the 2 groups. Incidences of short sacral fixation (< 10 mm) were significantly higher for the DS in both NDS (38.7%) and DYS (39.5%) groups. Incidences of screw pass were lowest for the MS in both NDS (43.4%) and DYS (47.4%) groups.
Sacral dysplasia locates the SIJ more distally and therefore affects the entry point locations and screw lengths for all screws in trans-articular SIJ fusion, compared with a non-dysplastic sacrum. Moreover, three-screw fixation risks the development of unstable DS fixation and a high extra-articular fixation rate in MS.
本研究评估了经关节骶髂关节(SIJ)融合术治疗非创伤性 SIJ 疼痛的技术充分性,考虑了不同程度的骶骨发育不良。
选择了 72 名个体(53.4±8.4 岁)单侧骶髂复合体的尸体 CT 数据。将 3D 模型重建成普通侧位射线照片,以标记 SIJ 的关节面。将受试者分为发育不良(DYS)和非发育不良骶骨(NDS)组。在侧位图像上用 5mm 的安全间隙虚拟引入直径为 10mm 的近端(PS)、中间(MS)和远端(DS)螺钉。在相应的轴位图像上,每个螺钉垂直于矢状面推进,同样用 5mm 的安全间隙。测量每个螺钉在侧位图像上进入 S1(S2)终板和相应的前骶骨缘的进钉点,以及轴向图像上的最大螺钉长度。确定每个螺钉是否穿过 SIJ。对不同类型的骶骨发育不良和螺钉进行了统计学比较。
38 例(26.4%)为 DYS,106 例(73.6%)为 NDS。DYS 组的所有螺钉进钉点均明显比 NDS 组更靠后。两组 PS 和 MS 螺钉长度差异有统计学意义。在 NDS(38.7%)和 DYS(39.5%)两组中,DS 短固定(<10mm)的发生率明显更高。在 NDS(43.4%)和 DYS(47.4%)两组中,MS 的螺钉通过率最低。
与非发育不良骶骨相比,骶骨发育不良使 SIJ 更靠后,从而影响经关节 SIJ 融合术中所有螺钉的进钉点位置和螺钉长度。此外,三螺钉固定增加了不稳定 DS 固定和 MS 高关节外固定的风险。