Suppr超能文献

个体微管和微管群体相对于临界浓度的行为:当临界浓度被核苷酸水解驱动分开时,就会发生动态不稳定性。

Behaviors of individual microtubules and microtubule populations relative to critical concentrations: dynamic instability occurs when critical concentrations are driven apart by nucleotide hydrolysis.

机构信息

Department of Chemistry and Biochemistry.

Department of Natural Sciences, Saint Martin's University, Lacey, WA 98503.

出版信息

Mol Biol Cell. 2020 Mar 19;31(7):589-618. doi: 10.1091/mbc.E19-02-0101. Epub 2019 Oct 2.

Abstract

The concept of critical concentration (CC) is central to understanding the behavior of microtubules (MTs) and other cytoskeletal polymers. Traditionally, these polymers are understood to have one CC, measured in multiple ways and assumed to be the subunit concentration necessary for polymer assembly. However, this framework does not incorporate dynamic instability (DI), and there is work indicating that MTs have two CCs. We use our previously established simulations to confirm that MTs have (at least) two experimentally relevant CCs and to clarify the behavior of individuals and populations relative to the CCs. At free subunit concentrations above the lower CC (CC), growth phases of individual filaments can occur ; above the higher CC (CC), the population's polymer mass will increase . Our results demonstrate that most experimental CC measurements correspond to CC, meaning that "typical" DI occurs below the concentration traditionally considered necessary for polymer assembly. We report that [free tubulin] at steady state does not equal CC, but instead approaches CC asymptotically as [total tubulin] increases, and depends on the number of stable MT nucleation sites. We show that the degree of separation between CC and CC depends on the rate of nucleotide hydrolysis. This clarified framework helps explain and unify many experimental observations.

摘要

临界浓度 (CC) 的概念是理解微管 (MT) 和其他细胞骨架聚合物行为的核心。传统上,这些聚合物被认为只有一个 CC,可以通过多种方式测量,并假定是聚合物组装所需的亚基浓度。然而,这个框架没有纳入动态不稳定性 (DI),并且有工作表明 MT 有两个 CC。我们使用之前建立的模拟来确认 MT 至少有两个与实验相关的 CC,并澄清个体和群体相对于 CC 的行为。在游离亚基浓度高于较低 CC(CC)时,单个纤维的生长阶段可能会发生;在较高 CC(CC)之上,群体的聚合物质量将会增加。我们的结果表明,大多数实验 CC 测量值对应于 CC,这意味着“典型”DI 发生在传统上认为聚合物组装所需浓度以下。我们报告说,稳态时的[游离微管蛋白]不等于 CC,而是随着[总微管蛋白]的增加呈渐近关系,并且取决于稳定的 MT 成核位点的数量。我们表明 CC 和 CC 之间的分离程度取决于核苷酸水解的速率。这个澄清的框架有助于解释和统一许多实验观察。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/6044/7202068/a42ead4b013f/mbc-31-589-g001.jpg

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验