Yu Yang, Yang Zhe, Zhong Jianjian, Liu Yanying, Li Jianling, Wang Xindong, Kang Feiyu
State Key Laboratory of Advanced Metallurgy, School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, No. 30 College Road, Haidian District, Beijing 100083, China.
Laboratory of Advanced Materials, School of Materials Science and Engineering, Tsinghua University, Haidian District, Beijing 100084, China.
ACS Appl Mater Interfaces. 2020 Mar 25;12(12):13996-14004. doi: 10.1021/acsami.0c00944. Epub 2020 Mar 16.
A gentle method is used to treat the precursor to induce the doping of SO and Ni. The doped SO induces the formation of oxygen vacancies and defects, which are beneficial for inhibition of the loss of O, stabilization of the structure, and amelioration of voltage decay, and the doped Ni increases the degree of lithium nickel mixing and significantly increases the midvoltage. After modification, the specific discharge capacity reaches 305.20 mAh g, with a Coulombic efficiency of 86.20% (the specific discharge capacity and Coulombic efficiency of the original material are only 276.50 mAh g and 77.30%, respectively). In addition, the cycle performance is also significantly improved, and the discharge midvoltage is dramatically increased from 2.74 to 3.00 V after 350 cycles at a large current density of 1C due to the dual-ion synergistic effect. In summary, these results show that the materials exhibit not only a more stable structure but also better electrochemical performance after modification.
采用温和的方法处理前驱体以诱导SO和Ni的掺杂。掺杂的SO诱导氧空位和缺陷的形成,这有利于抑制O的损失、稳定结构以及改善电压衰减,而掺杂的Ni增加了锂镍混合程度并显著提高了中压。改性后,比放电容量达到305.20 mAh/g,库仑效率为86.20%(原始材料的比放电容量和库仑效率分别仅为276.50 mAh/g和77.30%)。此外,循环性能也显著提高,由于双离子协同效应,在1C的大电流密度下经过350次循环后,放电中压从2.74 V大幅提高到3.00V。总之,这些结果表明改性后的材料不仅具有更稳定的结构,而且具有更好的电化学性能。