Short stem humeral components in reverse shoulder arthroplasty: stem alignment influences the neck-shaft angle.

INTRODUCTION

Shorter humeral reverse total shoulder arthroplasty (RTSA) stems may reduce stress shielding, however, potentially carry the risk of varus/valgus malalignment. This radiographic study's purpose was to measure the incidence of stem malalignment and thus the realized neck-shaft angle (NSA). The hypothesis was that malalignment of the stem is a frequent postoperative radiographic finding.

METHODS

Radiographs of an uncemented curved short stem RTSA with a 145° NSA were reviewed. The study group included 124 cases at a mean age of 74 (range 48-91) years. The humeral stem axis was measured and defined as neutral if the value fell within ± 5° of the longitudinal humeral axis. Angular values > 5° were defined as malaligned in valgus or varus. The filling ratio of the implant within the humeral shaft was measured at the level of the metaphysis (FR) and diaphysis (FR).

RESULTS

The average humeral stem axis angle was 4 ± 3° valgus, corresponding to a true mean NSA of 149 ± 3°. Stem axis was neutral in 73% (n = 90) of implants. Of the 34 malaligned implants, 82% (n = 28) were in valgus (NSA = 153 ± 2°) and 18% (n = 6) in varus (NSA = 139 ± 1°). The average FR and FR were 0.68 ± 0.11 and 0.72 ± 0.11, respectively. A low positive association was found between stem diameter and filling ratios (r = 0.39; p < 0.001); indicating smaller stem sizes were more likely to be misaligned.

CONCLUSION

Uncemented short stem implants may decrease stress shielding; however, approximately one quarter were implanted > 5° malaligned. The majority of malaligned components (86%) were implanted in valgus, corresponding to an NSA of > 150°. As such, surgeons must be aware that shorter and smaller stems may lead to axial malalignment influencing the true SA.

LEVEL OF EVIDENCE

Level IV, retrospective study.