Suppr超能文献

预测俯卧位牵引 X 线片在脊椎滑脱症中的矫正效果。

Predicting spondylolisthesis correction with prone traction radiographs.

机构信息

Department of Orthopaedics and Traumatology, The University of Hong Kong, Pokfulam, Hong Kong SAR, China.

出版信息

Bone Joint J. 2020 Aug;102-B(8):1062-1071. doi: 10.1302/0301-620X.102B8.BJJ-2020-0528.R1.

Abstract

AIMS

To determine the effectiveness of prone traction radiographs in predicting postoperative slip distance, slip angle, changes in disc height, and lordosis after surgery for degenerative spondylolisthesis of the lumbar spine.

METHODS

A total of 63 consecutive patients with a degenerative spondylolisthesis and preoperative prone traction radiographs obtained since 2010 were studied. Slip distance, slip angle, disc height, segmental lordosis, and global lordosis (L1 to S1) were measured on preoperative lateral standing radiographs, flexion-extension lateral radiographs, prone traction lateral radiographs, and postoperative lateral standing radiographs. Patients were divided into two groups: posterolateral fusion or posterolateral fusion with interbody fusion.

RESULTS

The mean changes in segmental lordosis and global lordosis were 7.1° (SD 6.7°) and 2.9° (SD 9.9°) respectively for the interbody fusion group, and 0.8° (SD 5.1°) and -0.4° (SD 10.1°) respectively for the posterolateral fusion-only group. Segmental lordosis (ρ = 0.794, p < 0.001) corrected by interbody fusion correlated best with prone traction radiographs. Global lumbar lordosis (ρ = 0.788, p < 0.001) correlated best with the interbody fusion group and preoperative lateral standing radiographs. The least difference in slip distance (-0.3 mm (SD 1.7 mm), p < 0.001), slip angle (0.9° (SD 5.2°), p < 0.001), and disc height (0.02 mm (SD 2.4 mm), p < 0.001) was seen between prone traction and postoperative radiographs. Regression analyses suggested that prone traction parameters best predicted correction of slip distance (Corrected Akaike's Information Criterion (AICc) = 37.336) and disc height (AICc = 58.096), while correction of slip angle (AICc = 26.453) was best predicted by extension radiographs. Receiver operating characteristic (ROC) cut-off showed, with 68.3% sensitivity and 64.5% specificity, that to achieve a 3.0° increase in segmental lordotic angle, patients with a prone traction disc height of 8.5 mm needed an interbody fusion.

CONCLUSION

Prone traction radiographs best predict the slip distance and disc height correction achieved by interbody fusion for lumbar degenerative spondylolisthesis. To achieve this maximum correction, interbody fusion should be undertaken if a disc height of more than 8.5 mm is attained on preoperative prone traction radiographs. Level of Evidence: Level II Prognostic Study Cite this article: 2020;102-B(8):1062-1071.

摘要

目的

确定术前俯卧位牵引 X 线片在预测退行性腰椎滑脱术后滑脱距离、滑脱角、椎间盘高度变化和脊柱前凸角的有效性。

方法

研究了 2010 年以来连续收治的 63 例退行性腰椎滑脱症患者的术前俯卧位牵引 X 线片。在术前站立位侧位、屈伸位侧位、俯卧位牵引位和术后站立位侧位 X 线片上测量滑脱距离、滑脱角、椎间盘高度、节段脊柱前凸角和全脊柱前凸角(L1 至 S1)。患者分为两组:后路外侧融合或后路外侧融合联合椎间融合。

结果

后路外侧融合联合椎间融合组节段脊柱前凸角和全脊柱前凸角的平均变化分别为 7.1°(标准差 6.7°)和 2.9°(标准差 9.9°),后路外侧融合组分别为 0.8°(标准差 5.1°)和-0.4°(标准差 10.1°)。后路外侧融合联合椎间融合组节段脊柱前凸角(ρ=0.794,p<0.001)经椎间融合校正后与俯卧位牵引 X 线片相关性最好。全脊柱前凸角(ρ=0.788,p<0.001)与后路外侧融合联合椎间融合组和术前站立位侧位 X 线片相关性最好。滑脱距离(-0.3mm(标准差 1.7mm),p<0.001)、滑脱角(0.9°(标准差 5.2°),p<0.001)和椎间盘高度(0.02mm(标准差 2.4mm),p<0.001)的差异最小。回归分析表明,俯卧位牵引参数最能预测滑脱距离的校正(校正的赤池信息量准则(AICc)=37.336)和椎间盘高度的校正(AICc=58.096),而滑脱角的校正(AICc=26.453)则最好由伸展位 X 线片预测。受试者工作特征(ROC)曲线截断值显示,俯卧位牵引椎间盘高度为 8.5mm 时,患者节段脊柱前凸角增加 3.0°,敏感性为 68.3%,特异性为 64.5%,提示后路外侧融合联合椎间融合可达到最大矫正效果。

结论

术前俯卧位牵引 X 线片最能预测退行性腰椎滑脱症后路外侧融合联合椎间融合术的滑脱距离和椎间盘高度矫正。如果术前俯卧位牵引 X 线片上获得的椎间盘高度大于 8.5mm,则应进行后路外侧融合联合椎间融合术,以获得最大矫正。

证据水平

Ⅱ级预后研究。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验