Suppr超能文献

多区域设计多焦点人工晶状体诱导的散光与方向有关。

Multizonal Design Multifocal Intraocular Lens-Induced Astigmatism According to Orientation.

出版信息

J Refract Surg. 2020 Nov 1;36(11):740-748. doi: 10.3928/1081597X-20200828-02.

Abstract

PURPOSE

To evaluate the differences in intraocular lens (IOL)-induced astigmatism according to differences in orientation of a multizonal multifocal IOL, the Precizon Presbyopic NVA IOL (Ophtec BV).

METHODS

The clinical study reviewed 80 eyes from 40 patients with cataracts who underwent Precizon Presbyopic IOL implantation. Residual astigmatism, as measured by autorefraction and manifest refraction, was investigated using vector analysis of eyes implanted with vertical (90 ± 30 degrees) and horizontal (180 ± 30 degrees) orientations of the first near segment of the IOL. In the ray-tracing simulation study, pseudophakic eyes with the Precizon Presbyopic IOL were modeled. The modulation transfer function (MTF) of each case was compared with respect to the amount of corneal astigmatism of the model eyes and the orientation of the first near segment.

RESULTS

The mean IOL-induced astigmatism measured by autorefraction was 0.68 ± 0.58 diopters (D) at 1 degree in the vertical orientation of the first near segment (n = 52) and 1.05 ± 0.81 D at 96 degrees in the horizontal orientation (n = 28). However, the mean IOL-induced astigmatism measured by manifest refraction was 0.14 ± 0.44 D at 171 degrees and 0.46 ± 0.40 D at 95 degrees. The MTF analysis showed that the highest MTF values were measured in eyes without corneal astigmatism in both the vertically and horizontally implanted IOLs.

CONCLUSIONS

Autorefraction measurement indicates induction of with-the-rule astigmatism by the Precizon Presbyopic IOL when implanted vertically with respect to the first near segment, and against-the-rule astigmatism when implanted horizontally. However, this astigmatism is clinically insignificant according to manifest refraction and ray-tracing simulation. [J Refract Surg. 2020;36(11):740-748.].

摘要

目的

评估多焦点人工晶状体(IOL)的不同方位对 IOL 诱导散光的影响,该多焦点人工晶状体为 Precizon 远视型 NVA IOL(Ophtec BV)。

方法

本临床研究共纳入 40 例白内障患者的 80 只眼,这些患者均接受了 Precizon 远视型 IOL 植入术。通过对垂直(90±30 度)和水平(180±30 度)方位的第一近光区的 IOL 植入眼进行客观折射和主觉折射的向量分析,研究残余散光。在光线追踪模拟研究中,对植入 Precizon 远视型 IOL 的模拟人工晶状体眼进行建模。比较了每个病例的调制传递函数(MTF)与模型眼的角膜散光量和第一近光区的方位之间的关系。

结果

垂直方位第一近光区(n=52)的 IOL 诱导散光平均值为 0.68±0.58 屈光度(D),1 度时为 1.05±0.81 D,水平方位(n=28)为 96 度。然而,主觉折射测量的 IOL 诱导散光平均值为 171 度时为 0.14±0.44 D,95 度时为 0.46±0.40 D。MTF 分析显示,在垂直和水平植入的 IOL 中,无角膜散光的眼的最高 MTF 值。

结论

客观折射测量表明,当第一近光区垂直植入 Precizon 远视型 IOL 时,会引起顺规散光,而当水平植入时,会引起逆规散光。然而,根据主觉折射和光线追踪模拟,这种散光在临床上并不显著。[J Refract Surg. 2020;36(11):740-748.]。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验