Influence of Abutment Fabrication Method on 3D Fit at the Implant-Abutment Connection.

PURPOSE

To three-dimensionally evaluate the internal fit at the implant-abutment interface of abutments fabricated with different workflows using a combination of the silicone replica technique and microcomputed tomography (μCT).

MATERIALS AND METHODS

Thirty abutments were fabricated to restore internal-connection implants and were divided into three groups according to fabrication method: (1) full digital (abutment machined using CAD/CAM system); (2) Ti-Base (prefabricated standard Ti-Base abutments); and (3) UCLA (UCLA-type abutments) (n = 10/group). Linear and volume measurements were performed to assess the internal misfit using a silicone replica of the implant-abutment interface misfit area, which was three-dimensionally reconstructed after μCT. The internal discrepancies in three different regions of interest (Gap, Gap, and Gap) were assessed. Data were statistically evaluated using ANOVA and Tukey test (P < .05).

RESULTS

Ti-Base and UCLA abutments presented significantly lower misfit volume (0.49 mm, 95% CI: ± 0.045 mm and 0.48 mm, 95% CI: ± 0.045 mm, respectively) and mean internal gap (25.20 μm, 95% CI: ± 3.14 μm and 27.97 μm, 95% CI: ± 3.14 μm, respectively) than the full digital group (0.70 mm, 95% CI: ± 0.045 mm; 34.90 μm, 95% CI: ± 3.14 μm) (P < .001), but did not differ from each other (P = .825). While Gap was significantly higher in the full digital group (P < .001), Gap and Gap did not demonstrate significant differences among groups. All regions were statistically similar within groups, except for Gap in the full digital group, which exhibited higher mean values compared to the other regions (P = .000). The 3D measurements for quantification of internal discrepancy were strongly associated with the 2D measurements.

CONCLUSION

Ti-Base and UCLA abutments exhibited better internal fit at the implant-abutment interfaces compared to a fully digitalized workflow (CAD/CAM custom abutments).