Wierzbicki Tomasz, Li Wei, Liu Yuming, Zhu Juner
Department of Mechanical Engineering, MIT, United States.
J Mech Phys Solids. 2021 May;150:104369. doi: 10.1016/j.jmps.2021.104369. Epub 2021 Feb 18.
The paper is concerned with the vibration characteristics of the Coronavirus family. There are some 25-100 receptors, commonly called spikes protruding from the envelope shell of the virus. Spikes, resembling the shape of a hot air balloon, may have a total mass similar to the mass of the lipid bi-layer shell. The lipid proteins of the virus are treated as homogeneous elastic material and the problem is formulated as the interaction of thin elastic shell with discrete masses, modeled as short conical cross-sectional beams. The system is subjected to ultrasonic excitation. Using the methods of structural acoustics, it is shown that the scattered pressure is very small and the pressure on the viral shell is simply the incident pressure. The modal analysis is performed for a bare shell, a single spike, and the spike-decorated shell. The predicted vibration frequencies and modes are shown to compare well with the newly derived closed-form solutions for a single spike and existing analytical solutions for thin shells. The fully nonlinear dynamic simulation of the transient response revealed the true character of the complex interaction between local vibration of spikes and global vibration of the multi-degree-of-freedom system. It was shown that harmonic vibration at or below the lowest resonant modes can excite large amplitude vibration of spikes. The associated maximum principal strain in a spike can reach large values in a fraction of a millisecond. Implications for possible tearing off spikes from the shell are discussed. Another important result is that after a finite number of cycles, the shell buckles and collapses, developing internal contacts and folds with large curvatures and strains exceeding 10%. For the geometry and elastic properties of the SARS-CoV-2 virus, these effects are present in the range of frequencies close to the ones used for medical ultrasound diagnostics.
本文关注冠状病毒家族的振动特性。病毒包膜壳上通常有25至100个受体,俗称刺突。刺突形状类似热气球,其总质量可能与脂质双层壳的质量相近。病毒的脂质蛋白被视为均匀弹性材料,该问题被表述为薄弹性壳与离散质量的相互作用,离散质量被建模为短锥形截面梁。该系统受到超声激励。利用结构声学方法表明,散射压力非常小,病毒壳上的压力就是入射压力。对裸露壳、单个刺突以及带有刺突的壳进行了模态分析。结果表明,预测的振动频率和模态与新推导的单个刺突的闭式解以及薄壳的现有解析解吻合良好。瞬态响应的全非线性动态模拟揭示了刺突局部振动与多自由度系统全局振动之间复杂相互作用的真实特性。结果表明,在最低共振模态或低于该模态的谐波振动可激发刺突的大幅振动。刺突中相关的最大主应变在几毫秒内就能达到很大值。文中讨论了刺突可能从壳上撕裂的影响。另一个重要结果是,经过有限数量的循环后,壳会发生屈曲和坍塌,形成内部接触和具有大曲率且应变超过10%的褶皱。对于新冠病毒的几何形状和弹性特性,这些效应出现在接近医学超声诊断所用频率的范围内。