Maliba Pharmacy College, Uka Tarsadia University, Surat 394350, India.
Toi Ohomai Institute of Technology, Mokoia Campus, Rotorua 3015, New Zealand.
Int J Pharm. 2021 May 1;600:120474. doi: 10.1016/j.ijpharm.2021.120474. Epub 2021 Mar 15.
Clozapine is widely used to treat schizophrenia as an atypical antipsychotic. Low solubility, poor dissolution rate, degradation in the gastrointestinal tract, high hepatic first-pass metabolism, and eventually less drug transfer in the brain are all issues with oral clozapine administration. On account of this poor pharmacokinetic parameters, the authors aimed to develop clozapine nanosuspension using (+)-alpha-tocopherol polyethylene glycol 1000 succinate (TPGS) and polyvinylpyrrolidone K-30 (PVP K-30) and deliver it through the intranasal route. The nanosuspension was prepared by the high-speed homogenization method with 3 full factorial design for optimization of the product. Quality Target Product Profile (QTPP) was enlisted before the product development. The amount of TPGS and speed of homogenizer were selected as independent variables whereas, particle size and drug permeation profile after 24 h (Y, %) were selected as dependent variables. As per the results of optimization, amount of TPGS and speed of homogenizer were chosen as 0.1% and 7000 rpm, respectively. The particle size of the optimized nanosuspension of clozapine was found to be 281 nm. The conversion of clozapine crystals to an amorphous form was verified by characterization studies (XRD and DSC). The drug permeability study showed 96.15% and 41.12% clozapine release after 24 h from nanosuspension and conventional suspension, respectively. The study of nasal cilio-toxicity (histopathological studies) demonstrated the appropriateness of nanosuspension for intranasal purposes. The single-dose in vivo pharmacokinetic analysis in the rat model showed a substantial increase in the therapeutic concentration of clozapine in the brain tissue in the case of intranasal nanosuspension (dose = 0.05 mg drug/0.1 mL, C = 8.62 ± 0.45 μg/g, t = 1 h) compared to conventional oral clozapine suspension (dose = 26.43 mg drug/0.158 mL, C = 1.14 ± 0.12 μg/g, t = 1 h).Ultimately, in the case of an intranasal route, a 3.56-fold increase in brain drug concentration was observed with a 528-fold lower drug dose compared with oral administration. The results suggest that clozapine nanosuspension may be used for successful nose-to-brain delivery.
氯氮平作为一种非典型抗精神病药物,被广泛用于治疗精神分裂症。然而,其口服制剂存在溶解度低、溶解速率差、在胃肠道中降解、肝脏首过代谢高以及最终向大脑的药物转移减少等问题。鉴于这些较差的药代动力学参数,作者旨在使用(+)-生育酚聚乙二醇 1000 琥珀酸酯(TPGS)和聚乙烯吡咯烷酮 K-30(PVP K-30)开发氯氮平纳米混悬剂,并通过鼻腔途径给药。该纳米混悬剂是通过高速匀浆法制备的,采用 3 因素完全实验设计对产品进行优化。在产品开发之前,列出了质量目标产品概况(QTPP)。TPGS 的用量和匀浆器的速度被选为自变量,而粒径和 24 小时后药物渗透情况(Y,%)被选为因变量。根据优化结果,选择 TPGS 的用量和匀浆器的速度分别为 0.1%和 7000rpm。优化后的氯氮平纳米混悬剂的粒径为 281nm。通过特征研究(XRD 和 DSC)证实了氯氮平晶体向无定形形式的转化。药物渗透研究表明,纳米混悬剂和常规混悬剂在 24 小时后分别释放 96.15%和 41.12%的氯氮平。鼻纤毛毒性(组织病理学研究)研究表明,纳米混悬剂适合鼻腔给药。在大鼠模型中的单次剂量体内药代动力学分析表明,与常规口服氯氮平混悬剂(剂量=0.05mg 药物/0.1mL,C=1.14±0.12μg/g,t=1h)相比,鼻腔纳米混悬剂(剂量=0.05mg 药物/0.1mL,C=8.62±0.45μg/g,t=1h)可显著提高脑组织中的治疗浓度。最终,在鼻腔给药的情况下,与口服给药相比,脑内药物浓度增加了 3.56 倍,药物剂量降低了 528 倍。研究结果表明,氯氮平纳米混悬剂可能用于成功的鼻内递药。