Suppr超能文献

由于厌氧过滤出水(AF)和水平流人工湿地(HFCW)出水导致的湿管灌溉堵塞。

Moistube irrigation fouling due to anaerobic filtered effluent (AF) and horizontal flow constructed wetland (HFCW) effluent.

机构信息

Agricultural Engineering Department, School of Engineering, University of KwaZulu-Natal, P.Bag X01, Pietermaritzburg, South Africa.

VarMac Consulting Engineers, Scottsville, Pietermaritzburg, 3209, South Africa.

出版信息

Sci Rep. 2021 Mar 29;11(1):7124. doi: 10.1038/s41598-021-86737-7.

Abstract

The study assessed the suitability of two effluent types, namely anaerobic filtered (AF) and horizontal flow constructed wetland (HFCW) effluent for Moistube irrigation (MTI). Secondary to this, the study determined the plugging coefficients (α) on MTI for the respective effluents. The feed water was supplied from a raised tank (3.5 m), and mass-flow rates were recorded at 15 min intervals using an electronic balance. The effluent feed water concentrations and experimental room temperature (25 °C ± 1 °C) were continuously monitored and kept constant. Hermia's models based on the [Formula: see text] coefficient was used to select the best fitting fouling mechanism model and, consequently, the plugging coefficients. In addition, microbial colony analysis and scanning electron microscopy (SEM) analysis was carried out to assess the composition of the deposited sediment (DS) and adhered bacterial film (ABF) onto the MTI lateral. The study revealed that MTI pore blocking was a complex phenomenon described by complete pore-blocking model ([Formula: see text] ≥ 0.50). Discharge followed an exponential decay with early fouling observed on AF effluent because of a high concentration of total suspended solids (TSS) and dissolved organic matter (DOM). Discharge declined by 50% after 20 and 10 h of intermittent operation for AF and HFCW effluent, respectively. The α for each effluent (foulant) were [Formula: see text] = 0.07 and [Formula: see text] = 0.05, respectively, for AF and HFCW. The microbial analysis revealed bacterial aggregation structures that contributed to pore blocking. SEM imaging revealed complete surface coverage by deposited sediment. It is concluded that water quality determines the operation life span of MTI, and the two effluents promote accelerated MTI pore fouling or blocking. Continuous use without flushing the MTI will promote membrane degradation and reduced discharge efficiency. Additional filtration can potentially mitigate the membrane degradation process.

摘要

本研究评估了两种出水类型,即厌氧过滤(AF)和水平流人工湿地(HFCW)出水对 Moistube 灌溉(MTI)的适用性。其次,本研究确定了各自废水中 MT 的堵塞系数(α)。供水来自高位水箱(3.5m),并使用电子天平每隔 15 分钟记录一次质量流量。连续监测并保持废水进料浓度和实验室温(25°C±1°C)恒定。根据[Formula: see text]系数,使用 Hermia 模型选择最合适的污垢机制模型,从而确定堵塞系数。此外,还进行了微生物菌落分析和扫描电子显微镜(SEM)分析,以评估沉积沉积物(DS)和附着在 MT 侧面上的细菌膜(ABF)的组成。研究表明,MTI 孔堵塞是一个复杂的现象,由完全孔堵塞模型([Formula: see text]≥0.50)描述。由于总悬浮固体(TSS)和溶解有机物(DOM)浓度较高,AF 废水在早期出现了严重的结垢现象,导致排放呈指数衰减。AF 和 HFCW 废水的间歇运行分别在 20 和 10 小时后,排放下降了 50%。每个废水(污垢物)的α值分别为[Formula: see text] = 0.07 和[Formula: see text] = 0.05,对于 AF 和 HFCW。微生物分析显示细菌聚集结构导致孔堵塞。SEM 成像显示沉积沉积物完全覆盖了表面。研究得出的结论是,水质决定了 MTI 的运行寿命,而这两种废水促进了 MT 的加速孔结垢或堵塞。如果不冲洗 MT,连续使用会促进膜降解和降低排放效率。额外的过滤可能会减轻膜降解过程。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/18d3/8007708/b64586f41cf8/41598_2021_86737_Fig1_HTML.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验