Simonescu Claudia Maria, Tătăruş Alina, Culiţă Daniela Cristina, Stănică Nicolae, Ionescu Ioana Alexandra, Butoi Bogdan, Banici Ana-Maria
Department of Analytical Chemistry and Environmental Engineering, Faculty of Applied Chemistry and Materials Science, Politehnica University of Bucharest, Polizu Street, No. 1-7, District 1, 011061 Bucharest, Romania.
National Research and Development Institute for Industrial Ecology, INCD ECOIND Bucuresti, 71-73 Drumul Podul Dambovitei Str., 060652 Bucharest, Romania.
Nanomaterials (Basel). 2021 Mar 12;11(3):711. doi: 10.3390/nano11030711.
(1) Background: A comparative research study to remove Congo Red (CR) and Methyl Orange (MO) from single and binary solutions by adsorption onto cobalt ferrite (CoFeO) and cobalt ferrite-chitosan composite (CoFeO-Chit) prepared by a simple coprecipitation method has been performed. (2) Methods: Structural, textural, morphology, and magnetic properties of the obtained magnetic materials were examined by X-ray diffraction (XRD), Fourier-transform infrared (FTIR) spectroscopy, N adsorption-desorption analysis, Scanning Electron Microscopy (SEM), Transmission Electron Microscopy (TEM), and magnetic measurements. The optimal operating conditions of the CR and MO removal processes were established in batch experiments. The mathematical models used to describe the processes at equilibrium were Freundlich and Langmuir adsorption isotherms. (3) Results: Cobalt ferrite-chitosan composite has a lower specific surface area (S) and consequently a lower adsorption capacity than cobalt ferrite. CoFeO and CoFeO-Chit particles exhibited a superparamagnetic behavior which enabled their efficient magnetic separation after the adsorption process. The research indicates that CR and MO adsorption onto prepared magnetic materials takes place as monolayer onto a homogeneous surface. According to Langmuir isotherm model that best fits the experimental data, the maximum CR/MO adsorption capacity is 162.68/94.46 mg/g for CoFeO and 15.60/66.18 mg/g for CoFeO-Chit in single solutions. The results of the kinetics study revealed that in single-component solutions, both pseudo-first-order and pseudo-second-order kinetics models represent well the adsorption process of CR/MO on both magnetic adsorbents. In binary solutions, adsorption of CR/MO on CoFeO better follows the pseudo-second-order kinetics model, while the kinetic of CR/MO adsorption on CoFeO-Chit is similar to that of the dyes in single-component solutions. Acetone and ethanol were successfully used as desorbing agents. (4) Conclusions: Our study revealed that CoFeO and CoFeO-Chit particles are good candidates for dye-contaminated wastewater remediation.
(1) 背景:通过吸附法从单一组分溶液和二元混合溶液中去除刚果红(CR)和甲基橙(MO)的比较研究已经展开,吸附剂采用通过简单共沉淀法制备的钴铁氧体(CoFeO)和钴铁氧体-壳聚糖复合材料(CoFeO-Chit)。(2) 方法:通过X射线衍射(XRD)、傅里叶变换红外(FTIR)光谱、N2吸附-脱附分析、扫描电子显微镜(SEM)、透射电子显微镜(TEM)和磁性测量等手段,对所制备磁性材料的结构、织构、形貌和磁性进行了研究。在分批实验中确定了CR和MO去除过程的最佳操作条件。用于描述平衡过程的数学模型为Freundlich和Langmuir吸附等温线。(3) 结果:钴铁氧体-壳聚糖复合材料的比表面积(S)较低,因此其吸附容量低于钴铁氧体。CoFeO和CoFeO-Chit颗粒表现出超顺磁性行为,这使得它们在吸附过程后能够进行高效磁分离。研究表明,CR和MO在制备的磁性材料上的吸附是以单层形式在均匀表面上发生的。根据最符合实验数据的Langmuir等温线模型,在单一组分溶液中,CoFeO对CR/MO的最大吸附容量为162.68/94.46 mg/g,CoFeO-Chit对CR/MO的最大吸附容量为15.60/66.18 mg/g。动力学研究结果表明,在单一组分溶液中,准一级动力学模型和准二级动力学模型都能很好地描述CR/MO在两种磁性吸附剂上的吸附过程。在二元混合溶液中,CR/MO在CoFeO上的吸附更符合准二级动力学模型,而CR/MO在CoFeO-Chit上的吸附动力学与单一组分溶液中染料的吸附动力学相似。丙酮和乙醇成功用作解吸剂。(4) 结论:我们的研究表明,CoFeO和CoFeO-Chit颗粒是用于修复受染料污染废水的良好候选材料。