Challenges in hemodynamics assessment in complex neurovascular geometries using computational fluid dynamics and benchtop flow simulation in 3D printed patient specific phantoms.

PURPOSE

Complex hemodynamics assessments, as those related to carotid stenosis, are not always easily straightforward due to multifaceted challenges presented by the collateral flow in the Circle of Willis (CoW) and brain flow autoregulation. Advanced computational and benchtop methods to investigate hemodynamics aspects related to such complex flows are often used, however both have limitations and could lead to results which may diverge. In this study we investigated these aspects by performing correlated computational fluid dynamics (CFD) simulations and benchtop experiments in patient specific 3D printed phantoms.

MATERIALS AND METHODS

To investigate the flow in patients with carotid stenosis, we built two patient specific phantoms which contained the arterial lesion of interest, all main arteries leading to the brain, the CoW and main arteries branching from it. Each phantom was connected to a generic aortic arch. A programmable pump was connected and flow parameters were measured proximal and distal to the lesion and the contralateral arteries. The patient 3D geometry was used to perform a set of CFD simulations where inflow boundary conditions matched the experimental ones. Flow conditions were recorded at the same locations as the experimental setup. Further exploration into the translation from experimental to CFD was also performed by customizing vascular segmentation and physically manipulating arterial compliance properties.

RESULTS

We initially observed significant differences between the CFD recordings and the experimental setup. Most of the differences were due to changes in phantom geometry when subjected to physiological pressures and simplistic outflow boundary conditions in the CFD simulations which do not account for pulsatility and nonlinear phenomena. Further work confirms the need for dynamic mesh behavior within CFD simulations attempting to computationally mimic 3D-printed benchtop experiments. Additionally, CFD simulation may benefit from considering geometry specific to a 3D-printed vascular phantom.