Ming Hongwei, Zhu Gaofan, Zhu Chen, Qin Xiaoying, Chen Tao, Zhang Jian, Li Di, Xin Hongxing, Jabar Bushra
Key Lab of Photovoltaic and Energy Conservation Materials, Institute of Solid State Physics, HFIPS, Chinese Academy of Sciences, Hefei 230031, China.
University of Science and Technology of China, 230026 Hefei, China.
ACS Nano. 2021 Jun 22;15(6):10532-10541. doi: 10.1021/acsnano.1c03120. Epub 2021 Jun 2.
As an eco-friendly thermoelectric material, CuSnSe has recently drawn much attention. However, its high electrical resistivity ρ and low thermopower prohibit its thermoelectric performance. Herein, we show that a widened band gap and the increased density of states are achieved S alloying, resulting in 1.6 times enhancement of (from 170 to 277 μV/K). Moreover, doping In at the Sn site can cause a 19-fold decrease of ρ and a 2.2 times enhancement of (at room temperature) due to both multivalence bands' participation in electrical transport and the further enhancement of the density of states effective mass, which allows a sharp increase in the power factor. As a result, PF = 9.3 μW cm K was achieved at ∼800 K for the CuSnInSeS sample. Besides, as large as 44% reduction of lattice thermal conductivity is obtained intensified phonon scattering by In-doping-induced formation of multidimensional defects, such as Sn vacancies, dislocations, twin boundaries, and CuInSe nanoprecipitates. Consequently, a record high figure of merit of ZT = 1.51 at 858 K is acquired for CuSnInSeS, which is 4.7-fold larger than that of pristine CuSnSe.
作为一种环保型热电材料,CuSnSe最近备受关注。然而,其高电阻率ρ和低热电势限制了其热电性能。在此,我们表明通过S合金化可实现带隙拓宽和态密度增加,从而使热电势增强1.6倍(从170 μV/K提高到277 μV/K)。此外,在Sn位点掺杂In可使ρ降低19倍,且(在室温下)使热电势增强2.2倍,这是由于多价带参与电输运以及态密度有效质量的进一步提高,进而使功率因子大幅增加。结果,CuSnInSeS样品在约800 K时实现了PF = 9.3 μW cm K²。此外,通过In掺杂诱导形成多维缺陷(如Sn空位、位错、孪晶界和CuInSe纳米沉淀)强化声子散射,晶格热导率降低高达44%。因此,CuSnInSeS在858 K时获得了创纪录的高优值ZT = 1.51,比原始CuSnSe高4.7倍。