Bukhtiyarov Andrey V, Prosvirin Igor P, Panafidin Maxim A, Fedorov Alexey Yu, Klyushin Alexander Yu, Knop-Gericke Axel, Zubavichus Yan V, Bukhtiyarov Valery I
Synchrotron Radiation Facility SKIF, Boreskov Institute of Catalysis SB RAS, 630559 Kol'tsovo, Russia.
Department of Physicochemical Techniques, Boreskov Institute of Catalysis SB RAS, 630090 Novosibirsk, Russia.
Nanomaterials (Basel). 2021 Dec 4;11(12):3292. doi: 10.3390/nano11123292.
In this study, the dependence of the catalytic activity of highly oriented pyrolytic graphite (HOPG)-supported bimetallic Pd-Au catalysts towards the CO oxidation based on the Pd/Au atomic ratio was investigated. The activities of two model catalysts differing from each other in the initial Pd/Au atomic ratios appeared as distinctly different in terms of their ignition temperatures. More specifically, the PdAu-2 sample with a lower Pd/Au surface ratio (0.75) was already active at temperatures less than 150 °C, while the PdAu-1 sample with a higher Pd/Au surface ratio (1.0) became active only at temperatures above 200 °C. NAP XPS revealed that the exposure of the catalysts to a reaction mixture at RT induces the palladium surface segregation accompanied by an enrichment of the near-surface regions of the two-component Pd-Au alloy nanoparticles with Pd due to adsorption of CO on palladium atoms. The segregation extent depends on the initial Pd/Au surface ratio. The difference in activity between these two catalysts is determined by the presence or higher concentration of specific active Pd sites on the surface of bimetallic particles, i.e., by the ensemble effect. Upon cooling the sample down to room temperature, the reverse redistribution of the atomic composition within near-surface regions occurs, which switches the catalyst back into inactive state. This observation strongly suggests that the optimum active sites emerge under reaction conditions exclusively, involving both high temperature and a reactive atmosphere.
在本研究中,研究了高度取向热解石墨(HOPG)负载的双金属Pd-Au催化剂对基于Pd/Au原子比的CO氧化反应的催化活性依赖性。两种初始Pd/Au原子比不同的模型催化剂的活性在点火温度方面表现出明显差异。更具体地说,具有较低Pd/Au表面比(0.75)的PdAu-2样品在低于150°C的温度下就具有活性,而具有较高Pd/Au表面比(1.0)的PdAu-1样品仅在高于200°C的温度下才具有活性。NAP XPS表明,在室温下将催化剂暴露于反应混合物中会导致钯表面偏析,由于CO吸附在钯原子上,双组分Pd-Au合金纳米颗粒的近表面区域会富集Pd。偏析程度取决于初始Pd/Au表面比。这两种催化剂之间的活性差异取决于双金属颗粒表面特定活性Pd位点的存在或更高浓度,即取决于整体效应。将样品冷却至室温后,近表面区域内原子组成会发生反向重新分布,使催化剂恢复到非活性状态。这一观察结果强烈表明,最佳活性位点仅在反应条件下出现,包括高温和反应性气氛。