Unit of Orthodontics and Pediatric Dentistry, Section of Dentistry, Department of Clinical, Surgical, Diagnostic and Pediatric Sciences, University of Pavia, Pavia, Italy.
Unit of Orthodontics and Pediatric Dentistry, Section of Dentistry, Department of Clinical, Surgical, Diagnostic and Pediatric Sciences, University of Pavia, Pavia, Italy.
Am J Orthod Dentofacial Orthop. 2022 Sep;162(3):297-306. doi: 10.1016/j.ajodo.2022.05.010. Epub 2022 Jun 7.
This double in vitro study and randomized clinical trial aimed to investigate the bonding failure rates of orthodontic brackets after enamel pretreatment with agents showing different particle sizes.
For the in vitro study, 80 bovine teeth were randomly divided into 4 groups according to the pretreating method used and their particle sizes: erythritol (14 μm), glycine (18-22 μm), sodium bicarbonate (70 μm), and no pretreatment. Scanning electron microscopy microphotographs were performed after pretreatment. Then, brackets were bonded, and shear bond strength was calculated. For the clinical study, agents with low (erythritol) and high (sodium bicarbonate) particle sizes were chosen. Twenty consecutive patients willing to start fixed orthodontic treatment with vestibular stainless steel brackets were enrolled. Patients were randomly divided into 2 groups following a split-mouth design. Group A underwent a 5-second enamel pretreatment procedure with erythritol for teeth belonging to maxillary left and mandibular right quadrants, whereas the remaining quadrants were pretreated for 5 seconds with sodium bicarbonate powder. In group B, quadrants were inverted. Then, brackets were bonded on the vestibular surfaces of teeth, and patients were visited monthly for 12 months to assess bond failures. Periodontal evaluation of probing pocket depth, bleeding on probing, plaque index, and papilla bleeding index was conducted before bonding and after 1, 3, 6, and 12 months.
The in vitro study showed that erythritol and control presented significantly higher shear bond strength values for other agents. Bicarbonate showed the lowest values. In the clinical study, 20 patients (aged 16.4 ± 3.9 years) were enrolled, and all completed the study. Erythritol showed a significantly lower failure rate (3%) than sodium bicarbonate (7.5%). Kaplan-Meier survival plots showed statistically significant differences in risk of failure between the 2 groups during the 12-month follow-up.
Enamel pretreatment with erythritol can be a viable technique to reduce failure rates of orthodontic brackets.
The trial was not registered.
The protocol was not published before trial commencement.
No funding or grant was received for this research.
本双盲临床研究旨在探究不同粒径的预处理剂对釉质预处理后正畸托槽脱落率的影响。
在体外研究中,80 颗牛牙根据预处理方法和粒径随机分为 4 组:赤藓糖醇(14μm)、甘氨酸(18-22μm)、碳酸氢钠(70μm)和无预处理。预处理后行扫描电镜观察。然后,粘结托槽,计算剪切粘结强度。在临床研究中,选择粒径较低(赤藓糖醇)和较高(碳酸氢钠)的试剂。连续 20 例愿意接受唇侧不锈钢方丝托槽固定正畸治疗的患者纳入研究。患者采用Split-mouth 设计随机分为 2 组。A 组使用赤藓糖醇预处理 5 秒,处理上颌左侧和下颌右侧象限的牙齿,其余象限用碳酸氢钠粉末预处理 5 秒。B 组相反。然后,将托槽粘结于牙齿唇面,患者每月就诊 1 次,共 12 个月,评估粘结失败情况。粘结前及粘结后 1、3、6、12 个月进行牙周探诊深度、探诊出血、菌斑指数和龈乳头出血指数检查。
体外研究显示,赤藓糖醇和对照组的剪切粘结强度值显著高于其他试剂。碳酸氢钠的粘结强度值最低。临床研究中,20 例患者(年龄 16.4±3.9 岁)完成了研究。赤藓糖醇的失败率(3%)显著低于碳酸氢钠(7.5%)。Kaplan-Meier 生存图显示,在 12 个月的随访中,两组之间的失败风险存在统计学差异。
赤藓糖醇预处理可降低正畸托槽脱落率。
本试验未注册。
试验开始前未发表方案。
本研究无资金或资助。