Discordance in lumbar bone mineral density measurements by quantitative computed tomography and dual-energy X-ray absorptiometry in postmenopausal women: a prospective comparative study.

BACKGROUND CONTEXT

Level-specific lumbar bone mineral density (BMD) evaluation of a single vertebral body can provide useful surgical planning and osteoporosis management information. Previous comparative studies have primarily focused on detecting spinal osteoporosis but not at specific levels.

PURPOSE

To compare the detection rate of lumbar osteoporosis between quantitative computed tomography (QCT) and dual-energy X-ray absorptiometry (DXA); to explore and analyze the distribution models of QCT-derived BMD and DXA T-score at the specific levels; and to evaluate the diagnostic accuracy of level-specific BMD thresholds for the prediction of osteoporotic vertebral compression fracture (OVCF) in postmenopausal women.

STUDY DESIGN/SETTING: A comparative analysis of prospectively collected data comparing QCT-derived BMD with DXA T-score.

PATIENT SAMPLE

A total of 296 postmenopausal women who were referred to the spine service of a single academic institution were enrolled.

OUTCOME MEASURES

QCT-derived BMD and DXA T-score at specific levels, with or without osteoporotic vertebral compression fracture.

METHODS

Postmenopausal women who underwent QCT and DXA within a week of admission from May 2019 to June 2022 were enrolled. The diagnostic criteria for osteoporosis recommended by the World Health Organization and the American College of Radiology were used for lumbar osteoporotic diagnosis. To evaluate differences in lumbar BMD measurements at specific levels, a threshold of T score=-2.5 and QCT-derived BMD = 80 mg/cm were used to categorize level-specific lumbar BMD into low and high BMD. Disagreements in BMD categorization between DXA and QCT were classified as a minor or major discordance based on the definition by Woodson. Data between QCT and DXA were visualized in a stacked bar plot and analyzed. Correlations between DXA and QCT at the specific levels were evaluated using Pearson's linear correlation and scatter plots. Curve fitting of BMD distribution, receiver operating characteristic (ROC) and area under the curve (AUC) for each single vertebral level was performed.

RESULTS

Of the 296 patients, QCT diagnosed 61.1% as osteoporosis, 30.4% as osteopenia and 8.4% as normal. For those screened with DXA, 54.1% of the patients had osteoporosis, 29.4% had osteopenia and 16.6% had normal BMD. Diagnoses were concordant for 194 (65.5%) patients. Of the other 102 discordant patients, 5 (1.7%) were major and 97 (32.8%) were minor. Significant correlations in level-specific BMD between DXA and QCT were observed (p<.001), with Pearson's correlation coefficients ranging from 0.662 to 0.728. The correlation strength was in the order of L1 > L2 > L3 > L4. The low BMD detection rate for QCT was significantly higher than that for DXA at the L3 and L4 levels (65% vs. 47.9% and 68.1% vs 43.7, respectively, p<.001). Patients with OVCF showed significantly lower QCT-derived BMD (47.2 mg/cm vs. 83.2 mg/cm, p<.001) and T-score (-3.39 vs. -1.98, p<.001) than those without OVCF. Among these patients, 82.8% (101/122) were diagnosed with osteoporosis by QCT measurement, while only 74.6% (91/122) were diagnosed by DXA. For discrimination between patients with and without OVCF, QCT-derived BMD showed better diagnosed performance (AUC range from 0.769 to 0.801) than DXA T-score (AUC range from 0.696 to 0.753).

CONCLUSION

QCT provided a more accurate evaluation of lumbar osteoporosis than DXA. The QCT-derived BMD measurements at a specific lumbar level have a high diagnostic performance for OVCF.